Beurer LB 88: Positioning the device 7. Operation 8. Cleaning and storage

Positioning the device 7. Operation 8. Cleaning and storage: Beurer LB 88

IMPORTANT

Donotaddanyessentialoilsorfragrancestothewater.Ifotheradditivesareused,theplastic

material and the ultrasound membrane may become discoloured and damaged.

Usefreshdrinkingwaterinthedevice.

Positioning the device

Placetheairhumidifieronafirm,levelandwater-resistantsurface.

Positiontheairhumidifierinthevicinityofaheatingpadtoimproveevaporationoutput,particularlyin

largerooms(donotexceedamax.temperatureof50°C).Alwaysensurethattheairinletandairoutlet

remain clear and that the air flows freely.

7. Operation

IMPORTANT

Checkthehumidityofyourambientairregularly.Intensivecontinuousoperationcancausetheam-

bientairtobecomeexcessivelyhumid.Therelativeairhumidityshouldnotexceed60%.

Switching on the device

•

I

nsert the plug into the mains socket.

•

F

rom the min./ position, turn the control dial to the right. The blue illuminated operating loop lights

up.Ifthereisnotenoughwaterornowateratallinthewatertank,aredLEDlightsup.Thedevicehas

switched off for safety reasons.

•

U

sethecontroldialtosetthedesiredevaporationoutput.Evaporationoutputislimitedtoamaximum

of550mlperhour.

• Whenthedeviceisswitchedon,thewaterevaporationlevelisalreadysetto1;asingleblueLEDshows

the operation. By pushing the middle control knob (

),thewaterevaporationlevelincreasesto2(second

blueLEDlightsup).Bypressingitagain,bothLEDsturnon–level3.(Evaporationlevel).Theevaporation

process is switched off completely when the button is pressed again (no LED on).

•

C

heckthewaterlevelregularlyduringoperationandrefillthetankifnecessary.

Note

You may optionally add drops of aroma/scented oils to the aroma compartment (13). These will lend

a pleasant odour to the room.

8. Cleaning and storage

Regular cleaning is a prerequisite for hygienic and fault-free operation.

The air humidifier can be dismantled easily and without tools for cleaning.

Alwaysemptyandthoroughlycleantheairhumidifierifthedevicecontainswaterandhasnotbeenoperated

for longer than 3 days.

A lack of cleaning and hygiene can cause bacteria, algae and fungi to form in the water.

Inanycase,werecommendthefollowingcleaningintervals.

Every three

As required

days

x Cleaning the ultrasound membrane with a brush, rinsing the base

x Rinsing the water tank, replacing the water

x Clean the air humidifier inside and out

x Descaling

NOTE

•

C

leanthedeviceusingonlythemethodsspecified.

•

U

nder no circumstances may liquid enter the base unit.

•

D

onotuseanysolvent-basedcleaningproducts.

18