Beurer BY 84: Rechargeable battery operation / disposable battery operation Mains operation 6. Operation Preparing the device for first use
Rechargeable battery operation / disposable battery operation Mains operation 6. Operation Preparing the device for first use: Beurer BY 84
Table of contents
- ENGLISH
- 2. Proper use 1. Getting to know your appliance
- 3. Important information Safety information General notes
- Notes on the use of batteries
- Parent unit 4. Appliance description Baby unit
- Baby unit / Parent unit 5. Start-up Setting the pilot tone Display
- Rechargeable battery operation / disposable battery operation Mains operation 6. Operation Preparing the device for first use
- 7. Settings Noise sensitivity (Baby unit) Volume (Parent unit) 8. Useful information about the baby monitor
- 9. Changing the batteries 11. In the event of problems Faults Action 10. Care and storage
- Faults Action Faults Action 12. Disposal
- 13. Technical details

Rechargeable battery operation /
battery down through normal use. Then
disposable battery operation
fully charge the battery up again.
•
Pull the battery compartment lid off from
•
The maximum battery capacity can only
the bottom.
be reached after it has been charged
•
Insert the included rechargeable batter-
several times and is dependent on many
ies or 3 x 1.5 V type AAA batteries the
factors (battery state, ambient tempera-
correct way round.
ture, means and frequency of charging
•
Close the battery compartment lid.
etc.).
•
The power supply unit must be con-
nected in order to charge the batteries.
Note
The battery level indicator shows that the
Observe the battery level indicator in the dis-
device is charging. As soon as the bat-
play and replace the batteries in good time.
teries are charged, the battery symbol
Mains operation
appears complete in the display.
•
The charging process lasts for approx.
Using the adapter plug, connect the units
10 hours when the device is switched
to a socket.
off.
6. Operation
Note
•
Position the transmitter so that it is in a
raised position at a distance of 2 m from
Preparing the device for first use
your baby.
•
Before the first use, the batteries should
•
Switch the transmitter on using the on /
be fully charged. The charging process
off / channel changer and select one of
lasts for approx. 10 hours. The device
the two channels.
offers an operation period of approx.
•
The display will begin to light up and the
16 / 22 hours after this.
selected channel is displayed.
•
You will get the maximum capacity from
•
Switch the receiver on by selecting the
your battery if you charge it at least once
same channel as that set on the transmit-
every 6 months. To do this, disconnect
the device from the mains and run the
19

