Beurer TL 90: Repairs 4. Unit description Overview 5. Initial use Positioning the device Mains connection 6. Operation 1 Switching on the lamp

Repairs

Important

• Donotopenthedevice.Pleasedonotattempttorepairtheunityourself.Thiscouldresultinseriousinju-

ries. Failure to observe this regulation shall void the warranty.

• Ifyouneedtohavetheunitrepaired,contactcustomerserviceoranauthoriseddealer.

4. Unit description

Overview

1. Fluorescent screen

1.

2. Rear of the device housing

3. Stand

4. On/Off button

2.

5. LED display

5. Initial use

Take the device out of the plastic wrapping. Check the

device for damage or faults. If you notice any damage or

faults on the device, do not use it and contact customer

3.

services or your supplier.

5.

4.

Positioning the device

Place the device on an even surface. The position should

be chosen to ensure a distance of between 20cm and

40cm between the user and the device. The lamp is most effective at this distance.

Mains connection

Connect the unit only to the mains voltage listed on the type plate. Push the plug completely into the mains

socket.

Note:

• Ensurethatthereisasocketneartheplacewherethelampwillstand.

• Laythemainscableinsuchawaythatnoonecantripoverit.

6. Operation

1 Switching on the lamp

 Press the On/Off button. The tubes turn on. Set the angle of the fluorescent screen in accordance

with your individual requirements.

ATTENTION!

The brightness of the tubes may be visibly different when switched on. The tubes develop

their full luminosity after a couple of minutes.

11