Hotpoint-Ariston LL 40: Start-up and use

6

EN

Starting the dishwasher

1. Open the water inlet valve.

2. Press the ON/OFF button: the machine will emit a

beep and the ON/OFF indicator light will illuminate.

3. Open the door and measure out a suitable amount

of detergent 

(see below)

.

4. Load the racks 

(see Loading the racks)

 and shut

the door.

5. Select the wash cycle by pressing the SELECT

WASH CYCLE button: the corresponding indicator

light will illuminate.

6. Select the wash options 

(see below)

.

7. Start the cycle by pressing the START/RESET

button: the machine will emit a confirmation beep.

The WASH CYCLE PHASE indicator lights display

the status of the cycle:

Pre-wash,   Wash,  Rinse,  or  Drying.

8. At the end of the cycle two short beeps will sound

and the DRYING indicator light will flash. Switch off

the appliance by pressing the ON/OFF button and

close the water inlet valve.

9. Open the door and wait for a few minutes before

removing the crockery inside, in order to avoid

burns. Unload the racks, beginning with the lower

level.

Modifying the duration of a wash cycle already in

progress

If a mistake was made during the wash cycle

selection process it is possible to change the cycle,

provided that it has only just begun:press and hold

the START/RESET button for 5 seconds After one

long beep and three short beeps, the WASH CYCLE

PHASE indicator light will switch off: select the new

cycle and switch the machine back on by pressing

the START/RESET button.

Recap Settings

Press the SELECT WASH CYCLE button:

The indicator light corresponding to the wash cycle

selected will illuminate.

Adding extra crockery

Press the ON/OFF button and open the door, taking

care to avoid the escaping steam, and place the

crockery inside the dishwasher. Press the ON/OFF

button again: the cycle starts from the point at which

it was interrupted.

Accidental  interruptions

If the door is opened during the wash cycle, or if

there is a power cut, the cycle stops. It starts again

from the point at which it was interrupted once the

door has been shut or the electricity supply is

restored.

Loading the detergent

A successful wash also depends on the correct

amount of detergent being used, as recommended

by the manufacturer. Exceeding the recommended

amount does not result in a more effective wash and

pollutes the environment.

Only use detergent which has been

specifically  designed  for  dishwashers.

DO NOT USE washing up liquid.

To obtain the best results from each washing

and drying cycle, powder detergent, rinse aid liq-

uid and salt should be used.

compar

compar

compar

compar

compartment A

tment A

tment A

tment A

tment A: Washing detergent

compar

compar

compar

compar

compartment B

tment B

tment B

tment B

tment B: Pre-wash detergent

1. Open cover C by pressing

button D.

2. Pour in the detergent after

consulting the 

Wash cycle

table

:

• for powder detergent use

compartments A and B

• for tablets, when the cycle

requires 1 tablet, place it in

compartment A and close the cover; when it requires

2, place the second tablet at the bottom of the

appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

A

B

D

C

Start-up and use

* Only available in selected models.