Beurer MG 158: 7. Care and storage CLEANING Storage 8. In the event of problems

WARNING

The massage must be pleasant and relaxing at all times. Stop the massage or change your position

or the contact pressure if you find it is painful or unpleasant.

Alternative use in the car

The massage seat cover can also be used in the car with the car adapter supplied. Plug the car adapter

connector plug into the connection jack on the device. Plug the car adapter into the cigarette lighter jack or

an alternative 12 V jack. (e.g. trunk). Operation proceeds as described above.

WARNING

Never have a massage with the massage seat cover while you are driving a car yourself. The

massage, as well as the device setting, distracts you from the road traffic. Your attention to the road

traffic must never be impaired by the device. Therefore only use this device as a passenger or if you

take a break and the vehicle is stationary. Please note that if the engine is off the battery can discharge

under certain circumstance. For some vehicles the 12 V jack only works when the engine is on.

A massage with this seat cover can be very relaxing and regenerating while taking breaks.

7. Care and storage

CLEANING

WARNING

•

Disconnect the device before cleaning it.

•

Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the

device or accessories.

•

Do not use the device again until it is completely dry.

First unplug the device and allow it to cool off. Then you can clean it with a cloth which is no more than lightly

moistened. You can also use a mild detergent.

Storage

•

Keep the massage device in a cool and dry place where it is out of the reach of children. We recommend

storing the device in its original packaging.

•

Avoid any contact with sharp or pointed objects which could damage the device or cover.

8. In the event of problems

Problem Cause Remedy

The device is

The seat cover is not fully in

Ensure that the seat cover is supported over its

very loud during

contact with the base.

entire area.

massage.

Massage stopped. The preset maximum period

Let the device cool down for at least 15 min.

of operation has elapsed.

before using again. Switch the device on again.

The connection to the mains

Check the plug connection and the contact of the

has been interrupted.

mains plug with the mains supply.

No massage. Appliance not connected to

Make all connections and switch on the device.

the mains power supply.

Device not switched on.

Turn the device on using

and activate the mas-

sage using buttons 2 – 4.

12