Hotpoint-Ariston SI DC30 BA0: iten BEFORE USE

iten

BEFORE USE

Selecting the temperature

LCD

and adjusting the steam (B

)

1

Beforeusingtheapplianceforthersttime,remove

all stickers, protective plastic or cardboard case from

1. Connect the plug of the appliance into a

the soleplate of the iron.

groundedsocket(220-240V).

Make sure that all adhesive parts have been

2. TheLCD(14)lightsupinredandstartsashing

removed from the soleplate with a dampened soft

to indicate that the iron is reaching the set

cloth and eliminate any residues or particles from

temperature.

themanufacturingprocess,byrepeatedlylling and

3. Use the temperature buttons +/- (4a) to select

emptying the water reservoir.

the desired temperature. An acoustic signal

is emitted every time you press one of the two

       

buttons,thedisplaylightsupandstartsashing

time, you may notice an unpleasant odour, a

to indicate that the steam iron is reaching the

little smoke and some impurities that will

selected temperature.

disappear in a few minutes. When using the steam

4. When the iron reaches the set temperature, an



acoustic signal is emitted, the LCD lights up in

jet on the garments because of the possible

greenandthesettemperatureisshowninxed

presence of manufacturing residues in the steam

mode to indicate that the iron is ready for use.

dispenser.

5. Make sure to check the garment label in order

Never add any perfume, vinegar, starch,

to identify the fabric type. In case of doubts, it

scale-removing agents, ironing products or

is recommended not to the use spray function

other chemicals in the water reservoir - unless

and iron a hidden corner in order to determine

recommended by Hotpoint-Ariston. Never use

the most appropriate temperature and avoid

contaminated water.

damaging the fabric. In case of very delicate

fabrics, such as silk, wool, and synthetic

Filling the water reservoir (A)

materials, iron the garment inside out to prevent

shiny marks. Start ironing the garments that

We recommend using demineralised water.

require a lower temperature, such as synthetic

fabrics.

Before lling the iron with water, make sure that

Fabrics with this symbol on the label

the iron is switched-off and disconnected from the

must not be ironed.

electrical socket.

GARMENT

TEMPERATURE

STEAM

FABRIC TYPE

1. Setthesteamregulator(3)toOff.

LABEL

INDICATION

INDICATION

2. Tilt the iron in such a position to make water

synthetic

entrance easier.

3. Openthelidofthellerhole(13)andllthewater

silk

mixed cotton

reservoir using the water measurer supplied with

theiron.Neverllthewaterreservoirabovethe

wool

mixed wool

maximumwaterlevel(10).

4. Closethelidofthellinghole.

cotton

linen

jeans

USING THE IRON

In order to make reading this instructions manual

easier and identify the model of your Quick Perfect

6. Select the steam level with the steam regulator

iron, refer to the graphics on page II.

(3)ormoveittoOfftoironwithoutsteam.When

steam ironing, make sure that the water level in

Your iron is supplied with Power Off System

the reservoir is at least ¼.

safety device which automatically switches

the iron off when it is left unattended or tips over

and ensures maximum safety.

24