Nikon PD-10: Troubleshooting En

Troubleshooting

En

If the camera cannot establish a strong connection to the PD-10 or if printing suddenly stops, check the following items.

Problem Possible cause/Solution

The POWER lamp on the PD-10 does not light. • Use fully-powered batteries.

• Check that the PD-10 is connected to the printer.

Unable to successfully set up the Profile Information on the

• Check that the printer is on and ready to print.

camera and PD-10./The camera cannot establish a strong

connection to the PD-10 (overall).

The camera cannot establish a strong connection to the

The wireless signal may be affected by something nearby. Move the camera and print-

PD-10./The connection is interrupted.

er closer together.

There is a problem with the wireless connection./The con-

The wireless signal may be affected by something nearby. Move the camera and print-

nection is interrupted.

er closer together. Perform a Reset, and then set up the Profile Information on the

camera again (c6).

Unable to successfully set up the Profile Information on the

Perform Steps 3 and 4 in “Setting Profile Information on the Camera” (c6 - 7) in rap-

camera and PD-10. (BUSY lamp blinks rapidly in orange.)

id succession. In Step 4, the START button must be pressed for two seconds.

Resetting

• If the Reset button is pressed for about one second while the PD-10 is on and connect-

ed to the printer, all of the Profile Information set in the PD-10 will be deleted.

• Press the Reset button with a small, thin object.

10

S

T

A

R

T

P