Gorenje wt62113: DETERGENTS AND ADDITIVES CLEANING THE FILTER/ DRAINING RESIDUAL WATER
DETERGENTS AND ADDITIVES CLEANING THE FILTER/ DRAINING RESIDUAL WATER: Gorenje wt62113
DETERGENTS AND ADDITIVES
CLEANING THE FILTER/ DRAINING RESIDUAL WATER
Keep detergents and additives in a safe, dry
Please note:
The washing machine is provided with a self-cleaning
4. Turn the filter slowly anti-clockwise until some
place out of the reach of children.
Too much detergent can result in excess foam
pump. The filter keeps objects like buttons, coins,
water starts to flow out; do not remove it as yet.
Do not use any solvents (e.g. turpentine,
formation, which reduces washing efficiency. If the
safetypins etc. which have been left in the laundry.
5. Wait until all the water has drained.
benzene); do not machine wash fabrics that
washing machine detects too much foam, it may
We recommend to check and clean the filter regularly,
6. Now unscrew the filter completely and extract it
have been treated with solvents or flammable
prevent spinning, or prolong the programme duration
at least two or three times a year.
(picture 19).
liquids.
and increase the water consumption (see also
Especially:
7. Clean the filter and the filter chamber.
Only use detergents and/or additives that are
remarks on foam formation in the “Troubleshooting
• if the appliance is not draining properly or if it fails
8. Make sure the pump impeller (in the housing
specifically produced for domestic washing
Guide”). Insufficient detergent may result in grey
to perform spin cycles.
behind the filter) is not obstructed.
machines. Observe the recommendations on the
laundry and also calcifies the heating system, drum
9. Insert the filter again and screw it in
care labels of your laundry.
and hoses.
• if the “Pump” indication lights up.
IMPORTANT: make sure the water has cooled
completely in clockwise direction. Make
The choice of detergent depends on:
Where to put detergents and additives
before draining the appliance.
sure the filter is screwed in properly, as far
• Type of fabric
(picture 17)
as it will go.
Residual water must be drained also before transport-
• Colour
Prewash chamber
ing the machine.
10. Pour approximately one litre of water into the
• Recommended wash temperature
washing machine via the drum and check that
• Detergent for the prewash phase (only if you
1. Unplug the washing machine.
• Degree and type of soiling
water does not leak from the filter.
have activated “prewash” option)
2. Open the filter cover with a coin (picture 18).
11. Close the filter cover.
Main wash chamber
3. Place a bowl beneath it.
Laundry type Kind of detergent
12. Reconnect the washing machine.
White robust laundry
heavy duty detergents with
• Detergent for the main wash phase (must be
(cold-95°C):
bleach
added for all wash programmes)
CARE AND MAINTENANCE
White delicate laundry
mild detergents with bleach
• Additive for stain removal (optional)
Always unplug the washing machine before doing any maintenance.
(cold-40°C):
and/or optical brighteners
• Water softener (optional; recommendable for
Light /pastel- shaded
detergents with bleach and/
water hardness class 4 or more)
Detergent dispenser
Water inlet hose (picture 22, 23 or 24,
colours (cold-60°C):
or optical brighteners
Clean the detergent dispenser regularly, at least
depending on model)
Softener chamber
Intensive colours
colour detergents without
three or four times a year, to prevent detergent
• Fabric softener (optional)
Check the inlet hose regularly for brittleness and
(cold-60°C):
bleach/optical brighteners
build-up:
cracks and replace it if necessary using a new hose of
• Starch dissolved in water (optional)
Black/dark
special detergents for black/
1. Press the button to release the detergent dispenser
the same type.
colours(cold-60°C):
dark laundry
Do not exceed the “MAX” level mark when filling in
and remove it (picture 20). A small quantity of
The inlet hose as shown on picture 22 has a safety
detergent, additives or softener.
water can remain in the dispenser, thus you should
valve to prevent the appliance against uncontrolled
For laundry requiring special treatment (e.g. wool
For more information regarding the application of
carry it in an upright position.
water inlet; if the safety valve inspection window (A) is
or microfibers), we recommend to use specialized
detergent and fabric softener in the programmes,
2. Wash the dispenser using running water. You can
red, the safety valve has been activated and the hose
detergents, additives or pre-treatment available on the
have a look at the separate program chart.
also remove the siphon cap on the back of the
must be exchanged. Contact out After-Sales Service
market. Refer to internet link www.cleanright.eu for
dispenser for cleaning (picture 21).
Using chlorine bleach
or your specialist dealer to obtain a new inlet hose.
more detailed information.
3. Replace the siphon cap in the dispenser (if
• Wash your laundry in the desired programme
For unscrewing the inlet hose as shown on picture 22,
Do not use liquid detergent for the main wash
removed)
(Cotton, Synthetics), adding an appropriate amount
you must push down the release lever (B) (if available)
when having activated the “Prewash” option.
of chlorine bleach to the SOFTENER chamber
4. Reinstall the dispenser by locating the dispenser’s
while unscrewing it.
Do not use liquid detergent when selecting a
(close the lid carefully).
bottom tabs into the appropriate openings on the
If your inlet hose has a transparent hose coating
later cycle start / cycle end (depending on the
lid, and by pushing the dispenser against the lid
• Immediately after end of programme, start the
(picture 23), periodically check the colour of the
model).
until it locks into place.
“Rinse and Spin” programme to eliminate any
transparent coating. If the transparent hose shows a
Dosage
residual bleach smell; if you want, you can add
Make sure that the detergent dispenser is
local dark colour change, this is an indication that the
softener.
correctly reinstalled.
hose may have a leak and should be replaced.
Follow the dosage recommendations on the detergent
Contact our After-Sales Service team or specialist
pack. They depend on:
• Never put both chlorine bleach and softener into
Water inlet hose filter
the softener chamber at the same time.
dealer to obtain a replacement hose.
• degree and type of soiling
Check and clean regularly (at least two or three
• size of wash
times a year).
Using starch powder
Appliance exterior and control panel
- full load: follow the detergent manufacturer’s
1. Unplug the washing machine.
• Wash your laundry in the desired wash programme.
• Clean with a soft damp cloth.
instructions;
2. Turn off the tap.
• Prepare the starch solution according to the starch
• If necessary, use some soapy water or a mild
- half load: 3/4 the amount used for a full load;
manufacturer’s instructions.
3. Unscrew the hose from the tap.
neutral detergent (do not use detergents containing
- minimum load (about 1 kg): half the amount used
solvents, abrasive detergents, window or general-
• Fill the prepared starch solution (maximum 100
4. Carefully clean the filter located at the end of hose,
for a full load
without disassembling it, for example with a tooth-
purpose cleaners - they may harm the surfaces).
ml) into the softener chamber of the detergent
If there is no reference to a certain wash load on
dispenser.
brush.
Appliance interior
the detergent pack: the detergent manufacturers
Note: Do not submerge the hose in water.
• Close the lid and start programme “Rinse and
• After each washing, leave the lid open for some-
usually refer their dosing recommendations to 4.5
Spin”.
5. Screw the flexible hose back onto the tap by hand.
time to allow the inside of the appliance to dry.
kg laundry for heavy duty detergent and 2.5 kg
Do not use pliers (risk of squashing the joint).
• If you never or seldom wash your laundry at
laundry for delicate detergent.
6. Turn on the tap and check that the connections
95°C, we recommend to occasionally run a 95°C
• water hardness in your area (ask for information
are water-tight.
programme without laundry, adding a small amount
from your water company). Soft water requires less
7. Plug the washing machine back in.
of detergent, to keep the interior of the appliance
detergent than hard water.
clean.
GB 7GB 6
Оглавление
- INTENDED USE
- BEFORE USING THE WASHING MACHINE DESCRIPTION OF THE WASHING MACHINE (picture 1)
- ELECTRICAL CONNECTION BEFORE THE FIRST WASH CYCLE
- DETERGENTS AND ADDITIVES CLEANING THE FILTER/ DRAINING RESIDUAL WATER
- TROUBLESHOOTING GUIDE
- ПРЕДПОЛАГАЕМОЕ ПРИМЕНЕНИЕ
- ОПИСАНИЕ СТИРАЛЬНОЙ МАШИНЫ (рис.1)
- ПЕРЕД ПЕРВОЙ СТИРКОЙ
- ЧИСТКА ФИЛЬТРА/ СЛИВ ОСТАВШЕЙСЯ ВОДЫ
- РУКОВОДСТВО ПО ПОИСКУ НЕИСПРАВНОСТЕЙ
- МАҚСАТТЫ ПАЙДАЛАНУ
- КІР ЖУУ МАШИНАСЫН ПАЙДАЛАНУДАН БҰРЫН КІР ЖУУ МАШИНАСЫН СИПАТТАУ (сурет 1)
- БІРІНШІ ЖУУ АЙНАЛЫМЫНАН БҰРЫН ЖУУ ҚҰРАЛДАРЫ МЕН ҚОСПАЛАР
- СҮЗГІНІ ТАЗАЛАУ/ҚАЛҒАН СУДЫ АҒЫЗУ
- ПРИЗНАЧЕННЯ ПРАЛЬНОЇ МАШИНИ
- ПЕРЕД ПОЧАТКОМ ВИКОРИСТАННЯ ПРАЛЬНОЇ ОПИС ПРАЛЬНОЇ МАШИНИ (мал. 1) МАШИНИ
- ПЕРЕД ПЕРШИМ ЦИКЛОМ ПРАННЯ ЗАСОБИ ДЛЯ ПРАННЯ ТА ДОБАВКИ
- ОЧИЩЕННЯ ФІЛЬТРА/ЗЛИВАННЯ ЗАЛИШКІВ ВОДИ
- ПОСІБНИК З УСУНЕННЯ НЕСПРАВНОСТЕЙ