Philips FC7070: 5 Using your AquaTrio

5.6 Active protection system is

3 If the active protection system was activated

activated

because the mopping brushes are too wet,

The active protection system has been designed

remove the mopping brushes and squeeze

to recognise when a foreign object other than dirt

them over the sink (see chapter ‘Cleaning and

ENGLISH



maintenance’, section ‘ Cleaning the mopping

system is activated, it stops the mopping brushes

nozzle’).

immediately to prevent damage to the object and

4 Place the mopping brush cover (1) and close

appliance. The motor sound decreases and the

the mopping brush lid (2). Press the mopping



nozzle lid (3) to lock it (‘click’), otherwise the

active protection system is also activated when

appliance is not reset.

the mopping brushes are too wet or when you

move the appliance over a carpet. To continue

cleaning, follow the instructions below!

1 Release the power-on button to switch off

the appliance (1). Put the appliance upright

in parking position (‘click’) and pull the plug

out of the wall socket. If the object picked up

is the cord of another appliance, unplug this

appliance as well (2).

5 Put the plug in the wall socket. Press the

parking position release button. Push the

unlock slide forwards (1) and press and hold

the power-on button (2). You can release the

unlock slide when the appliance switches on

(3). Keep the power-on button pressed to

continue cleaning.

2 Open the mopping nozzle lid (1), remove the

mopping brush cover (2) and take out the



can remove the mopping brushes to have a

better look.

5.6.1 Important to know

To reset the active protection system you need



sure you always remove any object from between

the mopping brushes before you switch on the

appliance.

13