Hotpoint-Ariston lsff 7m09 c: Special wash cycles and Options

Special wash cycles

and Options

Notes:

Half load using the upper or lower rack

EN

Optimum performance levels when using the “Express” cycles

If there are not many dishes to be washed, a half

can be achieved by respecting the specified number of place

load cycle may be used in order to save water,

settings.

electricity and detergent. Select the wash cycle and then

press the HALF LOAD button: the indicator corresponding

To reduce consumption even further, only run the dishwasher

to the chosen rack lights up and the wash cycle starts only

when it is full.

in the upper or lower rack.

Note for Test Laboratories: for information on comparative EN

Remember to load the upper or lower rack only, and

testing conditions, please send an email to the following address:

to reduce the amount of detergent accordingly.

assistenza_en_lvs@indesitcompany.com

Wash options*

Multi-functional tablets (Tabs)

This option optimises washing and drying results.

The OPTIONS may only be set, changed or reset after the

When using multi-functional tablets, press the MULTI-

wash cycle has been selected and before the Start/Pause

FUNCTIONAL TABLETS button; the corresponding symbol

button has been pressed.

will light up. If the button is pressed again, the option will be

Only the options which are compatible with the type of wash

deselected.

cycle set may be selected. If an option is not compatible

The “Multi-functional tablets” option results in a

with the selected wash cycle

(see Table of wash cycles)

, the

longer wash cycle.

corresponding symbol flashes rapidly 3 times.

If an option is selected which is not compatible with another

(previously selected) option, it will flash 3 times and switch

off, while the most recently selected option will remain active.

To deselect an option which has been set by mistake, press

the corresponding button again.

Delayed start

It is possible to delay the start time of the cycle by a

period of time between 1 and 24 hours:

1. Select the desired wash cycle and any other options

required; press the DELAYED START button. The indicator

light will go on. Use the same button to select when the wash

cycle will start (h01, h02 etc.)

2. Confirm the selection using the START/PAUSE button to

start the countdown.

3. Once this time has elapsed, the DELAYED START indicator

light goes off and the wash cycle begins.

To deselect the DELAYED START option, press the DELAYED

START button until the text OFF appears.

The Delayed Start function cannot be set once a wash

cycle has started.

* Only available in selected models.

15