Hotpoint-Ariston ct ntc ix2: PARTS AND FEATURES

hotpoint.

eu

12 en

PARTS AND FEATURES

1.  Water Machine Unit

2.  Reservoir Lid

3.  Reservoir

4. 

Dispensing  Button  and  Self  Monitoring  Sy

-

stem Warning

5.  Faucet

6.  Drip tray

7.  Screwdriver

IMPORTANT

• 

This appliance is for use with potable drin-

king  water  only.  Never  use  this  appliance 

with unknown or unsafe sources.

• 

This appliance needs a regular periodic 

maintenance to assure the drinkability requi

-

rements of treated water and improvements 

preservation as declared by the Manufactu-

rer.

• 

Check  if  the  voltage  indicated  on  the  ap

-

pliance corresponds to the local mains volta-

ge before you connect the appliance.

• 

Do not use this appliance if the mains cord, 

plug or other parts are damaged.

• 

Do not allow children to use the appliance 

without supervision.

• 

Never leave the appliance unattended when  

water  is being dispensed.

• 

For a cold refreshing drink the reservoir may 

be stored full of water in the fridge.

• 

Do not overfill the reservoir and do not leave 

the water goes below the min level marked 

on the reservoir: running the with a lower le-

vel of water will cause bubbling noises as the 

pump will then suck in air.

• 

Only use original parts from the manufactu-

rer to repair and service the unit.

• 

Only  use  Hotpoint-Ariston  [Hotpoint]  UV 

lamps and  filters with the appliance, failure 

to do so will void the warranty.

• 

The UV lamp will turn on for 60 seconds 

should the appliance not be used for 3 hours

• 

Make sure the appliance is placed on a flat, 

level, dry and  secure surface.

• 

Read all instructions contained in this user 

manual prior to using this appliance.

• 

This Class A system conforms to NSF Stan

-

dard 55 and  P231 for the disinfection of 

micro biologically contaminated water that 

meets all other public health standards. The 

system is not intended to convert wastewa-

ter  or  raw  sewage  into  drinking  water. The 

system is intended to be installed on visually 

clear drinkable water.

SET-UP

Check the unit for any damage, if the appliance is 

damaged then please return to the place of pur-

chase.

A1

Insert the plug into the mains socket. When 

the mains power is switched on the appliance will 

automatically  go  through  a  self  check/test  and  

once this is complete the button will turn blue.

A2

Remove the water  reservoir from the main 

body of the appliance .

A3

Remove the lid from the reservoir.

A4

Rinse the reservoir very well and then fill the 

reservoir from a potable water source. Do not 

overfill the reservoir. 

A5

Wash the lid thoroughly (for cleaning proce-

dures read point 3.1) and re-fit it to the reservoir.

A6

Re-fit the reservoir to the appliance making 

sure it is firmly fitted.

The steps A1-A6 can also be done wi-

thout removing the reservoir from the