Vitek VT-3539: RESOLVING MALFUNCTIONS Problem Resolution
RESOLVING MALFUNCTIONS Problem Resolution: Vitek VT-3539
Table of contents
- WEATHER STATION USER INSTRUCTIONS Features: Block with main display:
- Remote sensors: OPERATING CONTROLS
- READ BEFORE USING For best results: GETTING STARTED Step 1: Setting up the remote sensor:
- Step 2: Receiver settings SYNCHRONIZING THE OUTDOOR TEMPERATURE READING Auto-detect function: Manual learning function (Search for remote sensor signals):
- SETTING THE TIME AND ALARM Setting the time:
- WEATHER CONDITIONS DISPLAY
- Hi and Lo symbols on the display Temperature trend indicator The temperature trend indicator shows the temperature trend registered by a separate sensor over the past half-hour. TEMPERATURE CONDITIONS REPORT Temperature conditions reporting symbols Black ice warning
- TEMPERATURE ALARM SETTINGS High temperature alarm Low temperature alarm When the alarm will be heard
- BACKLIGHT USING AN EXTERNAL WIRED SENSOR LOW BATTERY INDICATOR Receiver:
- Remote sensor:
- RESOLVING MALFUNCTIONS Problem Resolution
- TECHNICAL CHARACTERISTICS Meteorological station receiver Meteorological station remote sensor MINIMUM SERVICE LIFE - 3 YEARS
ENGLISH
RESOLVING MALFUNCTIONS
Problem Resolution
Wait for 1-2 minutes so that the remote sensor
and the receiver can become synchronized. Sec-
Measurements on the
ond option: re-synchronize the remote sensor
1
remote sensor and the
and receiver by pressing and holding the Chan-
receiver do not match
nel button for 3 seconds, until an audible signal
is heard.
Temperature from the
Make sure that the sensor is not exposed to direct
2
external temperature
sunlight; the sensor should not be near any heat
sensor seems elevated
sources.
- Repeat the detection function.
The receiver has
- Maybe the temperature is less than -30°C
stopped receiving data
- The batteries need to be changed in the re-
3
from remote sensors
mote sensor
and displaying this data
- Move the remote sensor closer to the receiver
on the LCD
- Make sure the remote sensor is not located
near sources of radio interference.
The device is not work-
The device must be reinstalled. Reinstall the de-
ing properly or is not
4
vice by changing the batteries in the receiver and
completing certain
the remote sensor
functions
12
35391.indd 1235391.indd 12 23.05.2006 17:08:5223.05.2006 17:08:52
