Dell Latitude D510:  Speakers

 Speakers : Dell Latitude D510

Back to Contents Page

Speakers

Dell™Latitude™D510ServiceManual

1. Follow the instructions in "Preparing to Work Inside Your Computer."

2. Remove the palm rest.

3. Note the location of the coin-cell battery.

4. Remove the speaker cable from the speaker-cable routing clips.

5. Disconnect the speaker connector from the system board connector.

6. Remove the M2.5 x 5-mm screw labeled "B" from the speakers.

7. Gently pull the front of the computer base outward while lifting the speakers.

8. Disconnect the coin-cell battery from the speakers.

Back to Contents Page

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's

electronic components. You can do so by touching an unpainted metal surface.

NOTICE: To avoid damage to the speaker cable, be sure to re-route it through both securing clips. When inserting it back into each routing clip, slightly

bend open the clip with your finger, insert the cable, and then press the clip closed.

NOTICE: Handle the speakers with care to avoid damaging them.

1

speaker connector

2

M2.5 x 5-mm screw labeled "B"

3

coin-cell battery

4

coin-cell battery compartment

5

speakers

6

computer base

NOTICE: When replacing the speakers, be sure to replace the coin-cell battery in its compartment.