Konig Electronic Wireless microphone system: инструкция

KN-MICW512

MANUAL (p. 2)

NÁVOD K POUŽITÍ (s. 42)

ANLEITUNG (S. 6)

MANUAL DE UTILIZARE (p. 46)

MODE D’EMPLOI (p. 10)

ΕΓΧΕΙΡΙΔΙΟ XPHΣHΣ (σελ. 50)

GEBRUIKSAANWIJZING (p. 14)

BRUGERVEJLEDNING (s. 54)

MANUALE (p. 18)

VEILEDNING (s. 58)

MANUAL DE USO (p. 22)

ИНСТРУКЦИЯ (62 стр.)

MANUAL (p. 26)

KILAVUZ (s. 66)

HASZNÁLATI ÚTMUTATÓ (o. 30)

NÁVOD (s. 70)

KÄYTTÖOHJE (s. 34)

INSTRUKCJA OBSŁUGI (str. 74)

BRUKSANVISNING (s. 38)

Wireless Microphone System

ENGLISH

Introduction

Wireless microphone system with 1 channel for semi-professional use. Whether you use it for

a speech, singing debut or karaoke performance: there’s always a good sound.

Description receiver

6

7

2

3

4

5

2

1

1. ANTENNA: For the reception of the signals from the microphone

2. POWER INDICATOR: Lights up red when the receiver is powered on

3. RF SIGNAL INDICATOR: Lights up green constantly when microphone signal is received

4. PEAK INDICATOR: Flashes orange when the audio signal is too loud and will be distorted

5. VOLUME CONTROL: Adjusts the output volume of the receiver to the mixer or amplier

6. AUDIO OUT: Output of the audio signals for mixer or amplier

7. POWER INPUT: Connection for the DC plug of the AC/DC adapter

ENGLISH

Description microphone

1. GRILL: Covers and protects the inside microphone element

2. MICROPHONE ELEMENT (inside): Picks up the audio signal

3. POWER/BATTERY INDICATOR: Flashes once when the power is on and lights up

constantly when the battery is running out of power

4. ON/OFF SWITCH: 3 Positions for ON, MUTE (middle position) or OFF

5. BATTERY COMPARTMENT: For 2x AA batteries

6. BATTERY COVER: Provides access to the battery compartment

3

ENGLISH

Operation

1. Put the antenna straight up for optimal reception.

2. Connect the connection cable with the 6.35mm plugs to the output of the receiver and

mixer or amplier.

3. Connect the DC plug of the AC/DC adapter to the DC input on the rear side of the

receiver. Connect the power plug to a wall outlet.

Note: the receiver is automatically powered on.

4. Open the battery compartment of the microphone and place 2x AA batteries according

to the indicated polarity markers.

5. Switch on, after closing the battery compartment, the microphone with the ON/OFF

switch.

6. The system is ready to use.

Specications

Frequency: UHF 863MHz

Transmit power: 10mW

Dynamic range: >90 dB

Total harmonic distortion: <0.5%

Frequency response: 40 Hz–15 KHz, ±3dB

Modulation: FM

Audio output level: 0–400 mV

Power supply: 230~240 V AC, 17 V DC

Power consumption: 4 W

S/N ratio: >90 dB

Battery: 2x AA 1.5 V

Battery life: 4–6 hours

4

ENGLISH

Safety precautions:

CAUTION

RISK OF ELECTRIC SHOCK

To reduce risk of electric shock, this product should ONLY be opened by an authorized

DO NOT OPEN

technician when service is required.

Disconnect the product from mains and other equipment if a problem should occur.

Do not expose the product to water or moisture.

Maintenance:

Clean only with a dry cloth.

Do not use cleaning solvents or abrasives.

Warranty:

No guarantee or liability can be accepted for any changes and modications of the product or damage caused due to incorrect use

of this product.

General:

Designs and specications are subject to change without notice.

All logos brands and product names are trademarks or registered trademarks of their respective holders and are hereby recognized

as such.

Attention:

This product is marked with this symbol. It means that used electrical and electronic products should not be mixed with

general household waste. There is a separate collections system for these products.

This product has been manufactured and supplied in compliance with all relevant regulations and directives, valid for all member

states of the European Union. It also complies to all applicable specications and regulations in the country of sales.

Formal documentation is available upon request. This includes, but is not limited to: Declaration of Conformity (and product

identity), Material Safety Data Sheet, product test report.

Please contact our customer service desk for support:

via website: http://www.nedis.com/en-us/contact/contact-form.htm

via e-mail: service@nedis.com

via telephone: +31 (0)73-5993965 (during oce hours)

NEDIS B.V., De Tweeling 28, 5215 MC ’s-Hertogenbosch, THE NETHERLANDS

5