Vitek VT-3549 SR: SNOOZE FEATURE HOW TO STOP AN ALARM ALARM FEATURE HOW TO CHANGE THE TEMPERATURE ALARM SETTING PRECAUTIONS
SNOOZE FEATURE HOW TO STOP AN ALARM ALARM FEATURE HOW TO CHANGE THE TEMPERATURE ALARM SETTING PRECAUTIONS: Vitek VT-3549 SR
Table of contents
- INTRODUCTION DESCRIPTION
- A DISPLAY
- MAIN FEATURES: REMOTE UNIT A LED INDICATOR BEFORE YOU BEGIN
- BATTERY INSTALLATION: REMOTE UNIT BATTERY INSTALLATION: MAIN UNIT LOW BATTERY WARNING HOW TO USE THE TABLE STAND OR WALL MOUNTING GETTING STARTED
- HOW TO CHECK REMOTE AND INDOOR TEMPERATURES HOW TO READ THE KINETIC WAVE DISPLAY MAXIMUM AND MINIMUM TEMPERATURES AND HUMIDITY
- TEMPERATURE AND HUMIDITY TREND WEATHER FORECAST ATMOSPHERIC PRESSURE COMFORT LEVEL INDICATORS
- HOW TO CHECK THE BAROMETRIC PRESSURE
- HOW TO USE AND SCAN THE MOON PHASE DISCONNECTED SIGNALS TRANSMISSION COLLISION
- HOW TO SET THE RADIO CONTROLLED CLOCK CALENDAR CLOCK DISPLAY MODES HOW TO SET THE CLOCK MANUALLY HOW TO SET AND ARM THE ALARM
- SNOOZE FEATURE HOW TO STOP AN ALARM ALARM FEATURE HOW TO CHANGE THE TEMPERATURE ALARM SETTING PRECAUTIONS
- SPECIFICATIONS
ENGLISH
SNOOZE FEATURE
When the alarm sound is on, press the snooze key enter snooze mode. After 8 min-
utes, alarm sound will be wake up automatically. The snooze cycle will be restarted if
you press the snooze key again.
If you leave the alarm sound on for 2 minutes, it will enter snooze mode automatically
with maximum 3 times.
HOW TO STOP AN ALARM
Press [ALARM] on the unit to stop an alarm.
ALARM FEATURE
• Single Alarm
The alarm sound will be activated and the icon will be flashed once when it is armed
and the alarm time is reach.
Once it finished, it will be disabled automatically.
• Pre-Alarm
The pre-alarm sound will be activated and the icon will be flashed if outdoor tem-
perature under or equal two degree C.
Which is programmable 15, 30, 45, 60 or 90 minutes earlier than the weekday alarm
or single alarm time.
HOW TO CHANGE THE TEMPERATURE ALARM SETTING
1. Press once [TEMP ALARM] button.
2. Then Press and hold [TEMP ALARM] button for 2 seconds.
3. Enter the Hi [
] or Lo [ ] temperature alert setting value by using [] or []
button.
4. Press [TEMP ALARM] once to exit.
PRECAUTIONS
This product is engineered to give you years of satisfactory service if you handle it
carefully. Here are a few precautions:
1. Do not immerse the unit in water.
2. Do not clean the unit with abrasive or corrosive materials.
They may scratch the plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust, temperature or humidity,
which may result in malfunction, shorter electronic life span, damaged battery and
distorted parts.
4. Do not tamper with the unit’s internal components. Doing so will invalidate the war-
ranty on the unit and may cause unnecessary damage. The unit contains no user-
serviceable parts.
5. Only use fresh batteries as specified in the user’s manual.
Do not mix new and old batteries as the old ones may leak.
6. Always read the user’s manual thoroughly before operating the unit.
11
3549.indd 1149.indd 11 02.06.2006 16:59:3702.06.2006 16:59:37
