Главная > Инструкция к Ноутбуку Dell Latitude D500 > Palm Rest

Dell Latitude D500: Palm Rest

Palm Rest : Dell Latitude D500

Back to Contents Page

Palm Rest

Dell™Latitude™D500ServiceManual

1. Follow the instructions in "Preparing to Work Inside the Computer."

2. Remove the keyboard.

3. Remove the display assembly.

4. Remove the three M2 x 3-mm screws labeled "circle P" from the top of the palm rest.

5. Disconnect the touch pad connector from the system board.

CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

NOTICE: You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.

1

M2 x 3-mm screws (3)

2

top of the palm rest

6. Turn the computer over and remove the nine M2.5 x 8-mm screws.

7. Starting at the back center of the palm rest, use your fingers to separate the palm rest from the computer base by lifting the inside of the palm rest

while pushing in on the outside.

Back to Contents Page

1

back center of the palm

rest

2

touch pad connector

3

system board connector

4

computer base

1

M2.5 x 8-mm screws (9)

NOTICE: Carefully separate the palm rest from the computer base to avoid damage to the palm rest.

NOTE: When you reinstall the palm rest, attach the right side of the palm rest first.

Оглавление

Топ 10 инструкций

Другие инструкции

Dell Latitude D510 Dell Latitude D510 Dell Latitude D505 Dell Latitude D505 Dell Latitude D430 Dell Latitude D430 Dell Latitude D420 Dell Latitude D420