Vitek VT-3625: ISO TYPE CONNECTOR TA SEEK /TA ALARM (2) REPLACING THE FUSE USING THE RETUNE L / S FUNCTIONS (2)

ENGLISH

ISO TYPE CONNECTOR

(2) momentarily until the desired function

appears on the screen. Figure 1 shows the order

RCA jacks:

in which sound control functions are selected

Line out:

using the SEL button.

: Red (right)

: White (left)

Line in:

: Red (right)

: White (left)

Fig. 1 Sound control function selection

PLUG A

1.

1. Volume 2. Selection 3. Bass 4. Treble 5.

2.

Balance 6. Fader adjustment

3.

Rotate the knob to set the Bass, Treble, Channel

4. Memory +12 V

Balance and Fader level.

5. Car Antenna Output

6.

TA SEEK /TA ALARM (2)

7. +12 V (to ignition switch)

Press the SEL button for more than 2 seconds to

8. Ground (-)

activate the function selector for traffic notifica-

tion messages.

Note:

The TA SEEK or TA ALARM functions can be

(Plug A contact number 7) should be connected

chosen by rotating the VOL knob.

to the ignition switch of the car in order to avoid

2 sec.

discharging of the car battery when the engine

is turned off and the battery is not being

recharged.

 TA SEEK mode:

PLUG B

If a newly tuned station does not transmit traffic

1. Right rear speaker (+)

information within 5 seconds, the radio automat-

2. Right rear speaker (-)

ically tunes to the next station that transmits

3. Right front speaker (+)

traffic information.

4. Right front speaker (-)

In TA search mode, the current station can be

5. Left front speaker (+)

switched to another station if the signal is weak,

6. Left front speaker (-)

because the device is searching for TP-stations

7. Left rear speaker (+)

that have strong broadcast signals and are

8. Left rear speaker (-)

transmitting TP-signal information.

Maintenance

 TA ALARM mode:

REPLACING THE FUSE

With the TA search mode disabled, the radio will

If the fuse burns out, check the connection to

sound and audible alert when traffic information

power and replace the fuse. If the fuse burns out

is about to be broadcast.

again after being replaced then there may be

and internal malfunction. If this happens, con-

DPI Mask(2)

sult with your nearest service center.

The selection mode for this function is activated

Warning

upon holding down the SEL button for more than

Use a fuse of the indicated current level for each

2 seconds.

wire. Using fuses with high current levels can

lead to serious damage.

Operating Instructions

1. On/Off ( )

MASK DPI mode: masks radio stations on alter-

The device turns on and off when this button is

native radio frequencies (AF) that have differing

pressed and held.

program identifiers (PI) .

This device also turns on when any button is

MASK ALL mode: masks radio stations on alter-

pressed.

native radio frequencies with differing program

2. Selection

identifiers and the signal NO RDS.

3. Volume up/down

Turn this knob (3) to adjust the volume. To

USING THE RETUNE L / S FUNCTIONS (2)

choose other functions, press the SEL button

Upon pressing the SEL button for more than 2

5