Vitek VT-3479 BK: Top and front panels Power Supply BASIC FUNCTION RADIO

ENGLISH

Top and front panels

-inlet for power cord

1. VOLUME

23. BATTERY DOOR

- adjust volume level.

-to open battery compartment.

2. REMOTE SENSOR

-remote control signal sensor

Power Supply

3. FUNCTION SELECT

Using AC Power

- select source of sound MP3/CD,

1. Check if the power voltage, as shown on the

TAPE or RADIO, also the power off switch.

type plate located on the bottom of the set,

4. CD BACK ()

corresponds to your local AC power supply.

CD: - Skip track backwards.

If it does not, consult your dealer or service

5. PLAY/PAUSE BUTTON ()

centre.

- start or pause MP3/CD play

2. Connect the power cord to the AC MAINS

6. STOP BUTTON

inlet and the wall outlet. The power supply

- stop CD playback; erase a CD program.

is now connected and ready for use.

7.

CD NEXT()

3. To switch off completely, unplug the power

CD: - Skip track forwards.

cord from the wall outlet.

8. BAND SELECTOR (AM FM FM ST.)

• Unplug the power cord from the wall

- select AM/FM/FM ST. Waveband.

outlet to protect your set during heavy

9. STEREO HEADPHONE JACK

thunderstorms.

- 3.5 mm stereo headphone jack.

10. TELESCOPIC ANTENNA

Batteries (not included)

- to improve FM reception

Open the battery compartment and insert

11. TUNING CONTROL

eight batteries, type R-14, UM-2 or C-cells,

- select AM/FM/FM ST. Stations.

(preferably Alkaline) with the correct polarity

12. BASS BUTTON

as indicated by the + a,,nd - s,,ymbols

- enhances bass response

inside the compartment.

13. POWER BUTTON

- Switch the system on or to standby mode.

Batteries contains chemical substances, so

14. FM STEREO INDICATOR

they should be disposed of properly.

- show the FM stereo indicator

Incorrect use of batteries can cause electrolyte

15. CD DOOR

leakage and will corrode the compartment

16. CD DOOR OPEN BUTTON

or cause the batteries to burst. Therefore:

- press here to open/close the CD door.

• Do not mix battery types: e.g. alkaline with

17. LCD DISPLAY

carbon Zinc. Only use batteries of the same

- show the AM/FM dial frequency

type for the set.

- show the number of tracks

• When inserting new batteries, do not try to

18. REPEAT BUTTON

mix old batteries with new ones.

- repeat a track CD/MP3 program

• Remove the batteries if the set is not be

19. RANDOM BUTTON

used for a long time.

CD: - play CD tracks in random order

20. CASSETTE RECORDER KEYS

BASIC FUNCTION

PAUSE KEY(- interrupt recording or STOP/

RADIO

EJECT KEYC

 - stop the tape - open

Switching power on/off: Save energy Whether

the cassette compartment

you are using mains or battery supply, to avoid

F. FWD KEY (-ativance the tape toward the

unnecessary energy consumption always adjust

end).

the source selector to off.

F. REW KEY (-Rewind the tape toward the

For FM, pull out the telescopic antenna. Incline

beginning.

and turn the antenna. Reduce its length if the

PLAYKEY ( ) -start playback

signal is too strong (very close to a transmitter).

RECORDER () - start recording

For AM, the set is provided with a built-in

21. CASSETTE COMPARTMENT

antenna so the telescopic antenna is not

-put into the cassette

needed. Direct the antenna by turning the whole

22. AC MAINS

set.

6

3479.indd 63479.indd 6 11.04.2006 16:36:1311.04.2006 16:36:13