Vitek VT-8517 ST: STORAGE CLEANING AND CARE DELIVERY SET TECHNICAL SPECIFICATIONS

5

into the blender bowl (3), set the switch (7)

• Install the sealing gasket into the knife block

to the position “P” and hold the switch (7) for

(5).

1-3 seconds; repeat 8-12 times.

• Install the knife block (5) into the blender

– If you want tot mix water with ice (no more than

bowl (3). Use the measuring cup (1) to turn

10 cubes sized 2.5 cm x 2.5 cm x 2.5 cm), first

the knife block (5) counterclockwise as far

chop the ice as described above and then set

as it will go.

the switch (7) to the position “II” and let the

• When installing the knife block (5), do not

blender operate for 1-2 minutes.

apply excessive effort to avoid damage of

ATTENTION! Continuous operation time of

the sealing gasket.

the blender should not exceed 2 minutes;

after that switch the unit off and let it cool

STORAGE

down for at least 2 minutes.

• Perform the requirements of the CLEANING

AND CARE section before taking the unit away

CLEANING AND CARE

for storage.

After the unit operation is finished, switch the

• Keep the unit in a clean dry place out of reach

blender off by setting the operation mode switch

of children.

(7) to the “0” position and unplug it.

• Remove the blender bowl (3) from the motor

DELIVERY SET

unit (6) by turning it counterclockwise.

Table blender – 1 pc.

• Remove the measuring cup (1) from the lid (2).

Measuring cup – 1 pc.

• Remove the lid (2) from the bowl (3) taking it

Instruction manual – 1 pc.

by the ledge and take the processed products

out of the bowl (3).

TECHNICAL SPECIFICATIONS

• Wash the bowl (3) preliminarily.

Power supply: 220-240 V ~ 50 Hz

• Turn the bowl (3) upside down and unscrew

Maximum power: 900 W

the knife block (5) using the correspond-

Bowl capacity: 1.5 l

ing grooves on the measuring cup (1) (see

pic. 1). Remove the sealing gasket from the

The manufacturer preserves the right to change

knife block. Rotate the knife block counter-

the specifications of the units without a prelimi-

clockwise to unscrew.

nary notification

ATTENTION: The cutting edges of the knives

are very sharp and dangerous. Handle them

Unit operating life is 3 years

very carefully.

• Wash the bowl (3), the knife block (5) and

Guarantee

the sealing gasket with warm water and soft

Details regarding guarantee conditions can be

detergent and dry them.

obtained from the dealer from whom the appli-

• Clean the unit body with a soft damp cloth and

ance was purchased. The bill of sale or receipt

then wipe it dry.

must be produced when making any claim under

• Do not use coarse sponges, abrasives and

the terms of this guarantee.

solvents to clean the blender.

• Do not immerse the motor unit (6) into

any liquids; do not wash it in a dishwash-

This product conforms to the EMC-

ing machine.

Requirements as laid down by the Council

• Do not put the removable parts of the

Directive 2004/108/ЕС and to the Low

blender in a dishwashing machine.

Voltage Regulation (2006/95/ЕС)

VT-8517.indd 5 17.02.2016 17:19:54