Vitek VT-3109 SR: CARE AND MAINTENANCE Specifications

ENGLISH

tape forward.

matically disconnects the built-in speakers.

2. Press the REW button to rapidly wind the

tape backward.

CARE AND MAINTENANCE

• Check that there are no loose layers on

Recording from the Radio

tape. “Take up” these loose layers using a

. Set the FUNCTION selector to RADIO and

pencil before inserting the cassette into the

turn to the desired station.

cassette compartment.

2. Press the STOP/EJ button to open the

• Do not use the C-20 (or longer) cassettes.

cassette compartment door.

• Do not expose the unit to the extremes of

. Insert the cassette with the exposed portion

temperatures.

facing upward.

• Clean the tape handing parts (Play/record

4. Close the cassette compartment door by

head, pinch roller and capstan) after every

hand.

40-hours of operation with a cotton swab

5. Press the PAUSE button, and then press the

moistened with denatured alcohol.

REC button (PLAY button will be engaged

• Wipe away tough dirt with a soft cloth

simultaneously).

soaked in a neutral detergent.

6. To start recording, press the PAUSE button

• Clean the body with a soft cloth. Do not use

to release.

chemicals.

7. To stop recording, press the STOP/EJ

button. To eject the cassette, press the

Specifications

STOP/EJ button again.

Radio

General

Recording from Built-in Microphone

LW: 50-285 kHz

. Set the FUNCTION selector to TAPE.

2. Press the STOP/EJ button to open the

Output power: 0,5 W

cassette compartment door.

MW: 540-600 kHz

. Insert the cassette with the exposed portion

FM: 88-08 MHz

facing upward.

Dimensions: 294 х 27 х 40 mm

4. Close the cassette compartment door by

hand.

Antenna

5. Press the PAUSE button, and then press the

AM: Ferrite-bar antenna

REC button (PLAY button will be engaged

Mass: ~ , 5 kg (without batteries)

simultaneously).

FM: Telescopic antenna

6. To start recording, press the PAUSE button

to release.

Accessories: AC power cord

7. To stop recording, press the STOP/EJ

Tape

button. To eject the cassette, press the

Tape speed: 4,75 cm/sec.

STOP/EJ button again.

Power Requirements

Notes:

AC: 220 V ~ 50 Hz

• The recording level is adjusted

DC: 6 V, 4 х SUM- (“D” size, HP2, R20)

automatically. The VOLUME level does not

affect the recording level.

Specifications are subjected to change without

• If the sound on playback is distorted, the

notice.

microphone may have been placed too near

the recording source. Re-position the unit

The service life of the device is no less than

and run through the above procedure again.

five years.

Erase Protection

Guarantee

During recording, any previous recordings on

Details regarding guarantee conditions can

the tape are automatically erased. To avoid ac-

be obtained from the dealer from whom the

cidental erasure, remove the erase protection

appliance was purchased. The bill of sale or

tab on the cassette’s back edge. If you break

receipt must be produced when making any

the side A’s tab, you can not record on side A. If

claim under the terms of this guarantee.

you want to record on the tape, cover the tab’s

hole with a piece of plastic adhesive tape.

This product conforms to the EMC-

Requirements as laid down by the

Headphones Jack

Council Directive 89/6/EEC and to

For private listening, insert the earphone’s plug

the Low Voltage Regulation (2/7 EEC)

into the headphones jack of the unit. This auto-

4