Binatone HC-430: USEFUL TIPS

Mid-sized hair-cut (Fig. 4)

For this hair-cut, install the attachment (7 A or B) to the posi-

tion from 1 to 7 dependent on the area being cut (Fig. 4a). This

hair-cut gives a flat surface to the back of the head.

X The most important prerequisite for each hair-cut is to properly

dry hair before cutting. Dry the hair against the hair growth

direction to bristle the hair (Fig. 4b).

X Start hair cutting from the back and sides (Fig. 4а) (ref. to the

Short hair-cut section).

ENGLISH

X To enable you to obtain a smooth finish, use the barber hair-

brush (12) or fingers (Fig. 4с). Remove the hair-cutting at-

tachments (7 ) from the device. Using the barber hairbrush

(12) or fingers, lift a small hair strand (hair should be in a

vertical position as compared to the head), move the hairbrush

(12) or fingers along the strand length until you get the de-

sired length. The height of the cut strand is the example for the

next one. Continue cutting strand-by-strand, moving from the

back towards the forehead. Regularly comb hair to remove

cut strands and check the hair-cut results.

X For obtaining a smooth transition area (marked with a bold line

in Fig. 4а), located between the head back hair and the side

hair, slightly decline a flat hairbrush and cut-off the standing

hair (Fig. 4d).

X Cut hair-cut contours and whiskers as shown in the

Short hair-cut section.

Long hair-cut

This kind of hair-cut with hair cut off at the sides and at the back

gives long front hair.

X Cut the back and side hair following the procedure described

in the Short hair-cut section. Cut the hair only until the bold

line in Fig. 4а.

X Starting with this level (located several centimeters above the

ear), use a flat hairbrush to obtain a smooth transition zone.

Decline the hairbrush against the head and cut off the stand-

ing hair using the hair-cutting device without any attachment

(7). In this case the hairbrush serves as a guide (Fig. 4d).

X Do not cut hair from the top.

X Cut hair-cut contours and whiskers as shown in the Short

hair-cut section.

X Comb the hair as desired.

How to maintain the hair-cut

To maintain the hair-cut, from time to time trim the hair-cut

contours on the head back, whiskers and hair around the ears as

described in the Short hair-cut section. For this, no attachments

(7) is used.

Beard cutting

X Start cutting the beard under the chin. Move the device sym-

metrically either to one side, or to the other (Fig.5).

X Hair out of the beard contour should be cut with an upturned

device, with no tip attached. Cut hair in short careful moves.

11