Vitek VT-7160 W: Using the grid CRUMB TRAY Using the «DEFROST» button CLEANING AND CARE Using the «REHEAT» button

5

– Set the required toasting level using the

the lever (4) will return to its initial position

knob (8):

and the button illumination will go out. In this

«1» – minimal toasting level;

mode you can warm up toasts without addi-

«7» – maximal toasting level.

tional browning. Press the «STOP» button (7)

to cancel.

Notes: Set the control knob (8) to the position

you need. The toasting mode depends on the

Using the grid

thickness of the bread slice, bread sort and

If you want to warm up a roll, toast a slice of

quality; choose it experimentally.

bread only from one side or if the toast is of

Considering that heating element needs some

irregular size, use the grid (2).

time to heat up after the first switching on, the

– Press the lever (1), the grid (2) will extend.

toasting level of the first toasts will be less at

– Place a roll or a slice of bread on the grid

the same position of the knob (8). To obtain

(2).

the same toasting level at the same position of

– Set the toasting level using the knob (8):

the knob (8) let the unit cool down for no less

– Press the lever (4) until clamping.

than 30 seconds after switching off.

– When the toasts are ready, the unit will be

switched off automatically, the lever (4) will

– Press the lever (4) until clamping. The lever

return to its initial position.

(4) clamps only if the unit is plugged in.

– After the end of operation carefully lift the

After the lever (4) clamping the «STOP»

lever (1) to remove the grid.

button (7) illumination will light up.

– When the toasts are ready, the unit will be

CAUTION! During cooking the grid (2)

switched off automatically, the lever (4) will

heats up strongly. Let the toaster cool

return to its initial position. The «STOP» but-

down before using the grid.

ton (7) illumination will go out.

– To remove small toasts, carefully move the

Attention: If smoke appears, press the

carriage control lever (4) as upwards as

“STOP” button (7) immediately.

possible.

– If you want to stop the toasting process,

CRUMB TRAY

press the «STOP» button (7).

The toaster is equipped with a crumb tray (10).

Using the «DEFROST» button

– Switch the unit off and let it cool down.

To toast frozen toasts, put them into the slots

– Remove the tray (10), clean it off the

for bread toasting (3). Set the required toast-

crumbs and install the tray back to its place.

ing level with the knob (8), press the lever (4)

until clamping and then press the «DEFROST»

CLEANING AND CARE

button (5); the selected mode button illumi-

• Before cleaning the unit make sure that it

nation will light up. When the toasts are ready,

is unplugged.

the unit will be switched off automatically, the

• Wait until the toaster cools down com-

lever (4) will return to its initial position and the

pletely.

button illumination will go out. To cancel the

• Clean the outer surface of the toaster body

selected mode press the «STOP» button (7).

with a damp cloth and then wipe it dry.

• Do not use coarse sponges, abrasives and

Using the «REHEAT» button

solvents to clean the toaster.

You can warm up cold toasts. To do this, put

• Do not use metal sponges for cleaning.

the toasts into the slots for bread toasting (3)

Wire pieces may get into the toaster and

and press the carriage control lever (4) until

cause a short-circuit.

it is fixed. Press the «REHEAT» button (6), the

• To avoid injuries or damage of the unit,

button illumination will light up. After heat-

never insert foreign objects into the slots

ing the unit will be automatically switched off,

for bread toasting (3).

IM VT-7160.indd 5 25.07.2016 11:52:14