Vitek VT-4037 BN: TECHNICAL CHARACTERISTICS APPENDIX PRECAUTIONARY MEASURES:

ENGLISH

(2) Make sure the device is properly connected to the audio source.

• The device was subjected to rain; or

• The device is not functioning properly; or

4. NO SOUND IS COMING FROM THE CENTRAL SPEAKER

• The device was subjected to shock.

(1) Make sure the central speaker is properly connected to the

12. Repair service  The consumer should not attempt to repair the

device.

device himself. Use only the services of a qualified technician.

(2) Make sure the device is properly connected to the audio source.

13. Clean the device with a dry, soft clothe only.

(3) Increase the volume of the central speaker.

14. Turn off the device during thunderstorms or when not in use for a

long period of time.

5. NO SOUND IS COMING FROM THE REAR SPEAKERS

(1) Maker sure the rear speakers are connected properly.

TECHNICAL CHARACTERISTICS

(2) Make sure the device is properly connected to the audio source.

Power supply: ~220230 Volts

Output power: 60 W (Subwoofer)

NOTE: The central and rear speakers only work if the system is con

+ 5 x 35 W (Satellite speakers)

nected to a sixchannel audio source (for example, a DVD player with

Subwoofer speaker: 8"/4 Om

an AC3/Dolby Digital decoder) or, if in 3D mode, when connected

Satellite speakers: 2"/8 Om

through the 2.1 CH audio input.

Channel separation: >45 dB

Signal/noise ratio: >85 dB

APPENDIX

Reproducible frequency band:

When connecting the device to a DVD player with a builtin DD/DTS

35 Hz  200 Hz (Subwoofer)

decoder, verify the following:

150 Hz  20 KHz (Satellite speakers)

1. When connected through the 5.1 CH. audio input, the 5.1 CH audio

AM/FM Tuner

output should be chosen in the player's settings. Playback discs with

General FM tuner characteristics:

AC3/Dolby Digital 5.1 CH audio tracks.

Frequency band: 87.00 MHz ~108.00 MHz

2. To turn on the subwoofer, make sure that the speaker size in the

Frequency tuning step: 50/100 KHz

player's settings for the front, central and rear speakers is "Small"

Intermediate frequency of oscillation:

and that the subwoofer output is set to "On."

10.7 MHz

Temperature range: 5  +70°C

When connecting the device to DVD player, carefully read the operat

Antenna input impedance: 75 Om

ing instructions for the DVD player.

Signal/noise ratio: >45 dB

PRECAUTIONARY MEASURES:

General AM tuner characteristics:

Attention: Please carefully read the points listed below to ensure

Frequency band: 522 KHz ~ 1610 KHz

safe use of the device.

Frequency tuning step: 9/10 KHz

Intermediate frequency of oscillation:

1. Read the instructions  The safety instructions and operating

450 KHz

rules should be read before using the device.

Temperature range: 5  +70°C

2. Save the instructions  Save the instructions for future use.

Signal/noise ratio: >45 dB

3. Follow the operating rules  All of the safety instructions should

be followed.

4. Warning symbols  Heed the indications of all warning symbols

The technical characteristics of the device may be changed without

located on the device's panels or in these instructions.

prior notice.

5. Power source  The device should only be connected to a power

source with the characteristics indicated on the rear panel of the

Service life – no less than 5 years.

device or in these instructions.

6. Protecting the power cord  The power cord should be laid out in

Guarantee

such a way that it will not be damaged by external items or its

Details regarding guarantee conditions can be obtained from the

surroundings.

dealer from whom the appliance was purchased. The bill of sale or

7. Water and moisture  Do not use the device near reservoirs of

receipt must be produced when making any claim under the terms of

water (for example, bath tubs, sinks, etc).

this guarantee.

8. Ventilation  Install the device in a well ventilated room. Do not

install the device on couches, beds or carpets because the

This product conforms to the EMCRequirements as laid

device's ventilation may be blocked.

down by the Council Directive 89/336/EEC and to the Low

9. The effects of heat  Do not install the device near heat sources

Voltage Regulation (23/73 EEC)

(for example, radiators, kitchen stoves, etc).

10. Periods of nonuse  if the device will not be used for a long peri

od of time, disconnect the power plug from the electrical outlet.

11. The need for maintenance  Utilize the services of qualified tech

nicians if:

• The power cord is damaged; or

• The device body is damaged; or

6