Vitek VT-3623: LOCATION AND USE OF OPERATING CON- TROLS (ONLY ON THE REMOTE CONTROL CHARACTERISTICS FIXING MALFUNCTIONS

ENGLISH

heating or explosion and cause injury or fire.

Press the RESET button

2. Battery leaks can damage the remote control

unit (Battery life: 6 months when used in the

The front panel is not installed correctly

usual manner and under normal temperature

Install the front panel correctly

conditions).

3. Do not short-circuit the batterys poles.

The disc skips during playback

4. Do not dispose of the battery in an open flame.

The installation angle is greater than 30°

5. To avoid accidents, store the battery out of the

Adjust the installation angle of the player

reach of children.

The disc is dirty or scratched

LOCATION AND USE OF OPERATING CON-

Clean the disc / Insert a new one

TROLS (ONLY ON THE REMOTE CONTROL

UNIT)

The radio doesnt work, auto-tuning does

Remote

not work

control Front

The antenna cable is not connected.

unit panel

The signal is too weak

MUTE . . . . . . . .MU

Connect the antenna cable firmly

POWER . . . . . .PWR

Try to manually tune the desired station

MODE . . . . . . .MD

BAND . . . . . . . .BND

CHARACTERISTICS

+/- . . . . . . . . .VOL+/-

UP . . . . . . . . .:

GENERAL

DN . . . . . . . . .9

Power supply 13.8 V Direct Current.

Current use 5 A maximum.

FIXING MALFUNCTIONS

Output power 4 X 40W.

In order to fix the problem, read the following

FM

recommendations. If the problem persists, con-

Frequency band 66 MHz  108 MHz

tact your nearest service center.

Sensitivity3 uV.

I.F. Frequency 10.7 MHz.

No power

AM

The vehicles ignition is not on

Frequency band 522 KHz  1620 KHz

If the device is correctly connected to the vehi-

I.F. Freqency 450 KHz

cles power system, set the ignition switch to

Sensitivity 40 dB

ACC

LINE  OUT

Out CD MAX 1200 mv

The fuse is blown

CD PLAYER

Replace the fuse

System: compact disc audio system

Supported discs CD/CD-R/CD-RW/MP3

Disc wont load

Signal Format frequency of 44.1KHz.

There is already a disc in the player

Frequency band 10-20 KHz < 5dB.

Remove the disc from the player and then insert

CD Signal level 50 dB [1KHz]

a new one

Number of channels: 2 stereo.

Chassis dimensions:

Disc cannot be read

178[Width] X 50[Height] X 165[Length].

The disc is not loaded correctly

Insert the disc label-up

Due to constant upgrading, the characteristics

and design of this product may be changed

The disc is dirty or scratched

without prior notification.

Clean the disc or insert a new one

SERVICE LIFE OF THE UNIT NOT LESS 5 YEARS

It is too hot in the car

Cool the salon down to normal room tempera-

GUARANTEE

ture

Details regarding guarantee conditions can be

obtained from the dealer from whom the appliance

No sound

was purchased. The bill of sale or receipt must be

The volume is set too low

produced when making any claim under the terms of

Set the volume to the desired level

this guarantee.

The speaker wires are not connected properly

This product conforms to the EMC-

Check the speaker wire connections

Requirements as laid down by the Council

Directive 89/336/EEC and to the Low

Buttons dont work

Voltage Regulation (23/73 EEC)

The built-in microcomputer is not functioning

properly due to static electricity.

8