Vitek VT-3623: INSTALLATION INSTALLING THE UNIT IN YOUR AUTOMOBILE REMOVING THE FRONT PANEL CONNECTING THE SPEAKERS (FIG. D) DISC PLAYBACK: INSTALLATION EXAMPLE (FIG.1,2,3,4) REPLACING THE BATTERY IN THE REMOTE CONTROL UNIT: SAFETY MEASURES AND CARE NOTE REGARDING THE BATTERY IN THE REMOTE CONTROL UNIT:

ENGLISH

station with a stable signal is found, the current

panel.

frequency will blink for 5 seconds; press the but-

3. The device is designed for use in vehicles in

ton again to stop scanning and listen to the cur-

which the negative pole of the battery is con-

rent station, other wise the device will continue

nected to the chassis of the vehicle. Verify this

scanning every 5 seconds.

before installation.

4. Make sure that the speaker wires are not short-

INSTALLATION

ed-out before turning on the device. Otherwise

an overload could occur that might damage the

INSTALLING THE UNIT IN YOUR AUTOMOBILE

amplifier.

(FIG. B)

5. Do not attach the removable panel until the unit

1. The device

has been fully installed.

2. Guide rails

3. Front panel

Removal and installation of the front panel

4. Hex bolt

The front panel of this device can be removed in

5. Lock-nut

order to avoid theft.

6. Flat disc

7. Car body

REMOVING THE FRONT PANEL

8. Bracket

Before removing the decks front panel, turn off

9. Securing screws

the power by pressing button (1)POWER

10.M5 hex bolts X 15

ON/OFF (PWR).

Press the panel release button 14 to remove the

CONNECTING THE SPEAKERS (FIG. D)

front panel (REL), pull the panel towards your-

1. ANTENNA JACK

self.

2. ISO JACK

See the figure (5,6,7,8).

3. FUSES

Notes:

4. MEMORY B+ (YELLOW)

 Do not press too hard when installing the panel.

5. BLACK (GROUND-)

It freely snaps into place with light pressure.

6. RED (B+)

 When taking the panel with you, place it in the

7. BLUE ANTENNA POWER

supplied case.

8. FRONT LEFT SPEAKER

 Do not press hard on the LCD screen when con-

9. LEFT REAR SPEAKER

necting the front panel to the main unit.

10.WHITE

11.WHITE/BLACK

DISC PLAYBACK:

12.GREEN

Cleaning discs

13.GREEN/BLACK

Before playing a disc, wipe it with a clean, lint-

14.VIOLET/BLACK

free cloth. Wipe the disc in the direction of the

15.VIOLET

arrows.

16.RIGHT REAR SPEAKER

ATTENTION:

17.FRONT RIGHT SPEAKER

 Do not use solutions like gasoline and solvents.

18.GRAY/BLACK

Cleaning products and anti-static cleaners may

19.GREY

damage the device.

20.LINE AUDIO OUT JACK (RCA)

 Do not insert the disc label down. This can dam-

20a.RED - RIGHT

age the device.

20b.WHITE - LEFT

NOTE:

 Do not insert another disc while there is already

NOTE:

one in the player. This can damage the player.

1. Only use speakers with 4 ohms of resistance.

 Hold the disc by its edges. To keep the disc

2. Do not allow the antenna power wire to touch

clean, do not touch either of its surfaces.

metal elements of the vehicle or the rear panel

 Do not stick paper or film to discs.

of the player.

 Do not expose discs to the effects of direct sun-

light or high temperatures. Do not leave discs in

INSTALLATION EXAMPLE (FIG.1,2,3,4)

the car when parked in direct sunlight.

Installing in a dashboard

1. Remove the screws and clips.

REPLACING THE BATTERY IN THE REMOTE

3. CLIP. Break off these clips if necessary.

CONTROL UNIT:

Note:

Store the key in a reliable place, as you

1. Slide off the battery cover in the direction indi-

may need to remove the device from the car in

cated.

the future.

2. Replace the old battery with a new one, positive

SAFETY MEASURES AND CARE

(+) side up.

1. If it is very hot in the vehicle (after standing in

3. Replace the battery cover.

the sun, for example), turn on the player only

after the vehicle has been driven for a while and

NOTE REGARDING THE BATTERY IN THE

the salon has cooled down.

REMOTE CONTROL UNIT:

2. Use the supplied plastic case to store the front

1. Incorrect use of the battery can lead to over-

7