Phottix Odin for Canon: En

En

INSTRUCTION MANUAL

5. Press the Test button and  ashes will test  re in

Compatibility with Phottix Strato

sequence: Group A, followed by Groups B and C on

Series Flash Triggers

Strato II Multi Receivers.

The Phottix Odin o ers compatibility with Phottix Strato

6. If a group is disabled on the Odin TCU in TTL / Mixed

and Phottix Strato II Multi receivers. The Odin TCU will

Mode it will not trigger on Strato II Multi receivers.

trigger Strato receivers but will not transmit TTL or

7. Strato and Strato II Multi transmitters will not trigger

power control data. Strato series receivers will work as

Odin receivers.

they previously did: With  ashes set in Manual Mode.

1. The Odin TCU set on Channels 1, 2, 3 or 4 and in any

LED functions

group will trigger Phottix Strato receivers set on

The LED on the TCU and receiver units will turn green

Channels 1, 2, 3 or 4. Other Odin TCU functions will

when the camera is focusing and red when a photo is

not a ect Strato receivers.

being taken.

2. Press the Test button and  ashes with Strato receivers

will test  re as part of Group A.

Using the LCD Backlight

3. Strato II Multi receivers set to the same channel and

Pressing any button on the TCU will turn on the LCD

compatible group as the Odin TCU will trigger. The

Backlight for approximately 10 seconds. If no further

Odin TCU will not trigger Group D on Strato II Multi

buttons on the TCU are pressed the light will go o .

receivers. Other Odin TCU functions (TTL, Power

control) will not a ect Strato II Multi receivers.

Using the Modeling Light Button

4. The Odin TCU set to Channels 1, 2, 3 or 4 and in

Pressing the Modeling Light Button on the TCU will

Mixed/TTL mode (Groups A, B, C) and Ratio mode

cause all  ashes attached to Odin receivers to  ash for

(Groups A, B) are compatible with Phottix Strato II

one second. This is useful as a preview of lighting set-ups

Multi receivers on Channels 1, 2, 3 or 4 and Groups

or for focus-assist.

A, B, C.

4