Candy GOY 1050 D: I

“Pre-wash” button H

This option is particularly useful for heavily soiled loads and can be used only on some

programs as shown in the programs table.

Detergent for this program should be added to the compartment of the soap drawer la-

beled “1” (Please refer to Detergent Drawer Section of manual). We recommend you use

only 20% of the recommended quantities shown on the detergent pack and fabric condi-

tioner should not be used for this program.

"Spin speed" button

I

The spin cycle is very important to remove as much water as possible from the laundry

without damaging the fabrics. You can adjust the spin speed of the machine to suit your

needs.

By pressing this button, it is possible to reduce the maximum speed, and if you wish, the

spin cycle can be cancelled.

To reactivate the spin cycle is enough to press the button until you reach the spin speed

you would like to set.

For not damage the fabrics, it is not possible to increase the speed over that auto-

matically suitable during the selection of the program.

It is possible to modify the spin speed in any moment, also without to pause the machine.

NOTE: The machine is fitted with a special electronic device, which prevents the

spin cycle should the load be unbalanced. This reduces the noise and vibration in

the machine and so prolongs the life of your machine.

52

Digital display L

The display’s indicator system allows you to be constantly

informed about the status of the machine:

1) WASH TEMPERATURE

When a program is selected the relevant indicator will light up to

show the maximum possible wash temperature.

Selecting a lower temperature using the special button will c

ause

the corresponding indicator to light up.

NOTE: The temperature must be adjusted before selecting

DEGREE OF SOILING.

2) DOOR LIGHT

Once the "START/PAUSE" button has been pressed the light first flashes

then stops flashing and remains on until the end of the wash.

2 minutes after the end of the wash the light goes off to show that the door

can now be opened.

3) SPIN SPEED

Once the program has been selected, the maximum spin speed al-

lowed for that program appears on the display.

Pressing the spin button will reduce the speed by 100 rpm each time

the button is pressed. The minimum speed allowed is 400 rpm, or it is

possible to omit the spin by pressing the spin button repeatedly.

4) DELAY START LIGHT

This flashes when delay start has been set.

5) CYCLE DURATION

When a program is selected the display automatically shows the

cycle duration, which can vary, depending on the options se-

lected.

Once the program has started you will be kept informed con-

stantly of the time remaining to the end of the wash.

6) PROGRAM START LIGHT

This lights up when the "START/PAUSE" button has been

pressed.

53

7) DEGREE OF SOILING

When a program is selected the relevant indicator will light up to show

the minimum possible degree of soiling.

Selecting a greater degree of soiling using the special

button will cause the corresponding indicator to light up.

NOTE: The degree of soiling can vary automatically, depending on the temperature se-

lected

“Degree of soiling” button M

By selecting this button (active only on COTTON and MIXED FIBRES programs) there is a

choice of 3 levels of wash intensity, depending on how much the fabrics are soiled.

Once the program and wash temperature have been selected the degree of soiling indica-

tor is automatically set to the minimum allowed; pressing the button increases the level

and the settings for the cycle duration are also adjusted accordingly.

Program selector with "OFF" position N

When the program selector is turned the display lights

up to show the settings for the program selected.

N.B. to switch the machine off, turn the program selec-

tor to the “off” position.

Press the "Start/Pause" button to start the selected cycle.

The program carries out with the program selector stationary

on the selected program till cycle ends.

Switch off the washing machine by turning the selector to "OFF".

NOTE: The program selector must be return to the off position at the end of each

cycle or when starting a subsequent wash cycle prior to the next program being

selected and started.

Buttons indicator light O

These lights up when the relevant buttons are pressed.

If an option is selected that is not compatible with the selected program then the light on

the button first flashes and then goes off.

54

Detergent drawer P

The detergent drawer is split into 3 compartments:

- the compartment labeled "1" is for prewash detergent;

- the compartment labeled " " is for special additives,

fabric softeners, fragrances, starch, brighteners etc;

-

the compartment labeled "2" is for main wash deter-

gent.

NOTE:

Some Detergents are Difficult to utilise. Ensure to

use an in drum dispenser if recommended by the

detergent Manufacturer.

NOTE: only put liquid products in the compartment labeled “ ”. The machine is

programmed to automatically take up additives during the final rinse stage for all

wash cycles.

55