Binatone TP-3050: MAINTENANCE AND CLEANING

lease the button when the cup is full. Ten seconds later the

water dispense mode will be set and the indicator “Unlock” will

go out.

10.For water re-boiling, press the button “Boil”.

11.Before re-using the appliance, empty the water out - as water can

change its color and odor, and yellow spots could appear on the

heating element.

Attention: To fully pour water out from the bulb, do not use

button “Dispense”. Pour out water directly from the

internal bulb.

Use of the decorative replaceable panels

1. There are 2 additional replaceable panels for this device. To change

the design of the device carefully peel the existing panel by

its corner making sure that it has not torn. Then remove the new

panel from the paper base and paste it place of the panel you have

removed. Make sure that the glue of the panel has not dried up, then

you could use it again. The panel should be stored in the following

way; the new panel should be pasted onto a special place which

precisely repeats the form of the panel. Remove the protective

film and smooth the panel for the best fixing.

Attention: Please note that the paper base and a protective

film could be used next time, if they are kept smooth

and not rumpled.

2. Pay attention, that the replaceable panels have a limited life and

with correct storage, use and careful application you can re-use them

2-3 times.

MAINTENANCE AND

CLEANING

1. Before cleaning or storing, disconnect the

appliance from the power supply and wait

until the appliance is completely cooled.

2. To avoid electrical injuries, do not place the casing

(1) and power cable (11) in water. The parts of

the appliance as well as the internal bulb (2) can

be cleaned by using a damp lint free cloth.

3. Store the appliance only when completely dry.

HELPFUL HINTS

In areas with high water hardness, scale must

be regularly removed from the appliance to keep it

in good operating condition, since an excessive

scale in the appliance could result in the appliance

maloperation or failure. Frequency of de-scaling

depends on the tap water hardness in your region

and how often you use your thermopot. If water in

your house is hard, we recommend filtering it - this will decrease

the amount of deposited scale substantially.

8