Binatone TP-3050: BEFORE USING THE APPLIANCE

BEFORE USING THE

APPLIANCE

Read this operating manual which tells you

how to operate the appliance.

Before the first use of the appliance, boil

and pour out water several times.

ENGLISH

OPERATING MANUAL

1. Place the appliance on a dry horizontal sur-

face.

2. Open the lid (3), by turning it to the right.

When the mark «opened lock» on the lid coin-

cides with the arrow on the casing (1), remove

the lid.

3. Fill the thermopot with water; in doing so be

careful so that water does not splash onto the appliance casing

and its electrical parts.

Attention: Do not pour water in the thermopot from the side

where the control panel (5) is located. If water

penetrates inside the panel, this could result in

failures in the appliance operation.

4. Make sure that the water level does not exceed the maximum mark

on the water level indicator (9). Do not turn on the thermopot when

empty. Amount of water minimum required should not be lower

then the lowest mark on the water level scale.

Note: If the water level is lower than the small pipe on the

heating element, the protection system preventing

waterless operation activates and the appliance is

switched off.

5. Place the lid (3) on the casing (1) so that the arrows on the casing

and the mark «opened lock» on the lid concide. Close the lid (3),

turning it to the left. The mark «closed lock» on the lid (3) and the

arrow on the casing (1) should be coinside.

6. Connect the removable power cable (11) and insert the plug into

a power supply with voltage that should comply with the data on

the appliance.

Attention: Never connect the power cable if hands are wet.

7. When first connecting to a power supply, the indicator “Boil” will

light up and the thermopot will immediately start boiling.

8. Immediately after boiling the thermopot will enter the water tem-

perature maintenance mode. Indicator “Keep warm” will light up.

9. To pour water out of the thermopot, press the button “Unlock”

and release the preset locking mode. The symbol “Unlock” will

show that the locking mode is released. Place a cup under the

water supply port (6) and press the button “Dispense”. Re-

7