Binatone SI-2500: USEFUL TIPS

discharge from the sole plate (12) removing the scale and dust.

If the blast of steam becomes weaker, set the control knob (9)

into the “0” position and wait for 12-15 seconds until the iron

gets hot again. Then once again set the control knob into the

“Self-clean” position.

7. When the water tank (5) is completely empty, set the steam control

knob (9) into the “0” position.

8. Put the appliance into a vertical position and re-heat the iron.

9. To complete the cleaning process, iron a piece of a clean old cotton

cloth in order to clean the sole plate (12) of any remaining dust

and scale and to evaporate the remaining water. When you have

finished ironing, always switch the appliance off and disconnect

from the electrical supply.

Storage

Before storing the iron, make sure it is disconnected from the mains

supply outlet and is completely cooled down. Set the temperature

control knob into the “Min” position and the steam control knob into

the “0” position. Drain the remaining water from the tank (5) by

opening the cover (4) and holding the iron upside down over the sink.

Store the appliance in the upright standing position.

USEFUL TIPS

Selection of temperature settings

 Before ironing, we recommend that you organize

your clothes, into the types of material and the

recommended temperature settings.

 We recommend that you start ironing, using the

lower temperature settings first: the appliance gets

hot quicker than it cools down.

 When ironing articles made with combinations of fibers, start

with the temperature recommended for the most delicate ma-

terial first (for example, to iron a cloth made of cotton and

polyester select the temperature recommended for ironing

polyester first).

 If the manufacturer’s label, which gives the recommended

8