Binatone SI-2500: CARE AND MAINTENANCE

Burst of steam in a vertical position

This function helps to freshen the appearance of curtains, jackets,

coats, etc. To use this function, take the following steps:

 Follow instructions in paragraph 1-4 of the section “Operation

instructions”. While selecting the temperature setting, put the

temperature control knob (10) into the “Max” position.

 While holding the iron in a vertical position, aim its sole plate

towards the articles to be ironed and push the steam burst button

ENGLISH

(8) to produce a directional strong burst of steam from the sole

plate. Push the button several times with 5-7 seconds intervals

until the article is fully refreshed. If during the process your water

tank (5) runs out of water, disconnect the appliance from the

mains outlet, wait till it cools down, refill the tank and plug the

appliance back into the power supply and continue the process.

Spray

Using the water spray (7) will help when ironing details of the

article (cuffs, trimmings, plackets, etc) or clothes, which demand “•“

(low temperature) ironing, when steam ironing is not possible. Push

the button several times to moisten the material.

5. When you have finished cleaning or ironing, do not forget to switch

the iron off by putting the steam control knob (9) into the “0“

position, the temperature control knob (10) — into the “Min“

position and unplugging the appliance from the mains supply outlet.

CARE AND MAINTENANCE

Cleaning of the sole plate

 The scale on the sole plate can be removed with

a rough cotton cloth dampened with a vinegar

solution.

 Do not use any abrasive substances and

materials to clean the sole plate.

Cleaning of internal parts of the appliance

In areas with hard water it is recommended that you regularly

remove scale from the appliance to maintain it in good working order.

Excess lime scale may result in damage or malfunction of your product.

If in your area the water is soft and you have average amounts of

clothes to be ironed then we recommend you to de-scale every 6

months. If the water in your area is very hard or if you iron frequently,

then we recommend you de-scale once a month.

Your iron has a self-cleaning function, which allows you to clean

the internal parts of the appliance from scale or dust. To use this function

perform the following procedure:

1. Set the steam control knob (9) into the “0” position.

2. Fill the tank (5) with water to the “Max” level.

3. Place the iron in a vertical position and plug it into the mains supply

outlet.

4. Set the temperature control knob (10) into the “Max” position.

The light indicator (11) will light up showing that the iron is being

heated to the desired temperature.

5. When the iron reaches the maximum temperature, the light

indicator (11) will go out.

6. Whilst holding the appliance horizontally over a sink, set the steam

control knob (9) into the “Self-Clean” position. Hot steam will

7