Melissa 641-012: Auto shut-off ENVIRONMENTAL TIPS CLEANING THE GUARANTEE DOES NOT APPLY IMPORTER

16

Auto shut-off

• Place the steam iron on top of an

old tea towel or similar to dry before

To increase safety, the steam iron is

putting it away.

equipped with an auto shut-off function.

The handle (7) and water reservoir can

The thermostat automatically switches

be wiped over with a damp cloth and, if

the heat off after 30 seconds if the iron

necessary, a little detergent.

is lying motionless flat on its soleplate,

Never use a scouring sponge or

and after 8 minutes if the iron is standing

abrasive cleaning agents for cleaning the

upright on its end.

soleplate.

Once auto shut-off is activated, the

The spray nozzle can be cleaned, if

indicator light (6) flashes and the iron

necessary, using a special needle.

beeps six times.

• Lift or move the iron to deactivate the

ENVIRONMENTAL TIPS

auto shut-off function.

• The indicator light goes out, and the

Once any electrical product is no longer

thermostat light begins to glow.

functional, it should be disposed of

• Continue ironing once the thermostat

in such a way as to cause minimum

light goes out again.

environmental impact, in accordance with

the regulations of your local authority. In

CLEANING

most cases you can take such products

to your local recycling station.

The steam iron has an automatic cleaning

function, and we recommend cleaning

THE GUARANTEE DOES NOT APPLY

the iron thoroughly once every 14 days

(possibly more frequently if using very

- If the instructions given above are not

hard water) as follows:

observed.

• Set the temperature control dial to MIN

- If the device has been mishandled,

position.

subjected to rough treatment or has

• Remove the plug from the socket.

suffered any other form of damage.

• Fill the water reservoir right up to MAX

- If the appliance has been subject to

(300 ml – see ‘Filling with water’), and

unauthorised repairs.

close the water reservoir cover.

• Set the temperature control dial to

Due to the constant development of our

position •••, plug the iron in and switch

products in terms of function and design,

on the power.

we reserve the right to make changes to

• Wait until the thermostat light goes

the product without prior warning.

out. Hold the steam iron horizontal

IMPORTER

over a sink, and turn the steam setting

selection knob to the cleaning setting

Adexi Group

and pull it up.

• Hot water and steam will now run out

We cannot be held responsible for any

of the holes in the soleplate, and any

printing errors.

calcium deposits and impurities will

be washed out. Shake the steam iron

gently from side to side until the water

reservoir is empty.

• Repeat the cleaning procedure if large

quantities of calcium deposits were

washed out of the iron.

• Replace the knob with the valve, and

turn the steam setting selection knob

to position b (no steam), and the

thermostat button to MIN.

• Remove the plug from the socket.