Melissa 243-009: LIST OF COMPONENTS USING YOUR DEEP FRYER BEFORE FIRST USE DISMANTLING THE DEEP FRYER ASSEMBLING OF THE DEEP FRYER

AT-058 IM 03/07/03 14:25 Side 15

LIST OF COMPONENTS

USING YOUR DEEP FRYER

6.

- We advise that you use liquid oil, which is

5.

3.

8.

recommended for deep fat frying.

2.

1.

- Ensure the appliance is switched off. Slowly

7.

add the oil to the fryer untill the required

9.

level is reached (between the minimum and

4.

the maximum indications)

10.

- Set the temperature control knob to the

temperature you require. Switch on the

11.

1. Handle

appliance the red ON/OFF lamp will switch

2. Basket

on.

3. Immersed heating element

- When the oil is heating, the green

4. Outer jacket

thermostatic light will be illuminated. When

5. Filter lid

the oil reaches the set temperature, the light

6. ON/OFF switch

will go out. The thermostat will cycle on and

off to indicate when the appliance is heating

7. Temperature control light

the oil and when the desired oil temperature

8. Temperature control knob

has been reached.

9. Control box housing

- For best results, always wait until the

10. Cord storage area

appliance is at the correct temperature

11. Internal bowl

before adding food.

- Place the food to be fried carefully in the

BEFORE FIRST USE

basket. With the handle attached to the

- Remove the lid, basket, handle, controlbox

basket, gently lower the basket into the oil.

and the bowl from the outer jacket.

- For"crispy" result, we recommend using the

- Clean the lid, basket, handle, bowl and the

fryer without the lid. Be very careful of

outer jacket in hot soapy water and dry

spitting hot oil.

thoroughly.

- Always switch off the appliance and unplug

- Do not immerse the controlbox in any liquid.

from the power supply after use or whilst

unattended.

DISMANTLING THE DEEP FRYER

- Should you accidentally switch ON the

- Remove the controlbox from the appliance.

deep fryer without oil or fat or without the

To do this, gently pull the controlbox

minimum amount of oil required, the deep

upwards.

fryer will automatically cut-out, to stop the

- Take the bowl with both hands and pull it

appliance from overheating.

up slightly.

- If this happens, first switch-off the appliance

ASSEMBLING OF THE DEEP FRYER

and unplug from outlet. Wait until the

elements are cooled down. Pull out the

- Place the outer jacket on a heat resistant

cord-set, place your finger inside the

dry level surface.

storage area and push upwards onto the

- Replace the bowl until it rests on the top

small red button marked RESET.

edge of the outer jacket.

- This will reset the deep fryer. The deep fryer

- Replace the controlbox. To replace the

is now ready to use.

controlbox, firmly slide the controlbox down

- Should you wish to use solid fat, turn the

the two grooves on the back of the outer

temperature knob to its lowest position. Cut

jacket. The appliance will only operate when

the solid fat into cubes of size 15-20 mm.

the control panel is correctly fitted to the

Switch on the deep fryer and rotate the

temperature dial until the light comes on.

outer jacket.

15