Melissa 640-046: KEY TO THE VACUUM CLEANER’S PREPARING THE VACUUM CLEANER PARTS USE

640046_IM 15/08/05 9:11 Side 19

KEY TO THE VACUUM CLEANER’S

PREPARING THE VACUUM CLEANER

PARTS

• Attach the hose (4) to the vacuum cleaner by

inserting it into the hose connector (7) until

you hear a click. To remove the hose, press

the buttons at the side of the hose and pull it

out of the hose connector.

• Fit the telescopic tube (3) into the other end

of the hose, and attach the floor nozzle (1) to

the end of the tube.

•You can adjust the length of the telescopic

tube by pushing the locking mechanism (2)

down and pulling on the bottom section of

the tube until it reaches a suitable length.

When parking, shorten the tube as far as

possible.

1. Floor nozzle

• The vacuum cleaner’s combination nozzle

1a. Brush change button

(19) is used for particular vacuuming tasks

2. Locking mechanism

(see under Use). Remove the floor nozzle

3. Telescopic tube

and fit the combination nozzle to the end of

4. Hose

the telescopic tube.

5. Air valve

USE

6. Handle

• Pull the cord (15) out of the vacuum cleaner.

7. Hose connector

The cord must not be pulled out any further

8. Dust container

than the red mark. Plug in and switch the

9. Release button

power on.

10. Carrying handle

•Press the on/off button (12) to start and stop

11. Button for automatic cord rewind

the vacuum cleaner.

12. On/Off button

• While in use, the suction strength can be

13. Button for controlling suction strength

regulated by opening and closing the air

14. Parking holder

valve (5) on the handle at the end of the

15. Cord and plug

hose.

16. Exhaust filter

• The suction strength can also be adjusted

electronically using the button for controlling

17. Holder for combination nozzle

suction strength (13). Suction strength

18. Window for dust container

increases when the button is turned towards

19. Combination nozzle

"Max", and reduces when it is turned

19a. Combination nozzle, extended

towards "Min".

19