Melissa 635-072: VOLTAGE SWITCH 120V/230V INVIRONMENTAL TIP THE WARRENTY DO NOT COVER: SURFACE COATING CARE OF THE AIR CURLER BRUSH RELEASE IMPORTER: WARNING

AB312 IM 20/05/05 15:20 Side 11

VOLTAGE SWITCH 120V/230V

5. Always remove the mains plug of your appliance after use and before clea-

INVIRONMENTAL TIP

The curler must only be connected to the mains voltage marked on its housing.

ning it.

An electronic appliance should, when it is no longer capable of functioning be

Check that the switch is set to the mains voltage of your area. OTHERWISE THE

6. Take care that your hair does not come near the air intake (suction) (5).

disposed with least possible environmental damage. The appliance should be

EQUIPMENT MAY SUFFER SERIOUS DAMAGE, NOT COVERED BY THE

disposed according to the local regulations in your municipality, in most cases you

GUARANTEE.

Children do not understand the risks from incorrect handling of electrical

can discharge the appliance at your local recycling centre.

First remove the plug from the mains socket. Use a coin to turn the switch to its

appliances. Children should therefore not use the air curler without the supervision

proper position.

THE WARRENTY DO NOT COVER:

of an adult.

* if the above points have not been observed.

SURFACE COATING

CARE OF THE AIR CURLER

* if the appliance has not been properly maintained, if force has been used aga-

Your new equipment has been given a special surface coating around its housing.

For correct functioning the air curler must be kept clean.

inst it or if it has been damaged in any other way.

When the equipment is on for the first time, some smoke may be formed when

1. Blocked or clogged air intake valves can cause appliance overheating. Pull

this coating is being heated. This is not dangerous! The smoke will disappear after

* errors or faults owing to defects in the distribution system.

about 30 seconds.

out the Mains plug when cleaning is required and remove dust and textile

* if the appliance has been repaired or modified or changed in any way or by

fibres from the air openings with a small brush or a vacuum cleaner.

any person not properly authorized.

BRUSH RELEASE

2. The exterior surfaces of the appliance should only be cleaned off with a moist

When you wish to detach the curl/curls!

cloth and then wiped dry.

Owing to our constant development of our products on both functionality and

3. When cleaning of the round brush is required, release it from the appliance,

design we reserve the right to change the product without preceding notice.

Press the brush release button (3). Grasp the tip of the round brush (8) and roll out

the curl.

let it cool and clean with a small brush or a dry cloth.

IMPORTER:

NOTE!

WARNING

Adexi group

1. Do not let any kind of spray come into contact with the curler.

NEVER pull the mains plug by the cord or allow the cord to become twisted.

Never wind the cord around the appliance. The flexible cord holder may then be

2. Avoid getting your curler wet (water spray etc.) and do not use it with your

damaged,

hands wet. If laying the curler aside while drying and styling your hair, always

Causing cord breakage and short-circuiting. Check the cord often for possible

disconnect it from the mains as an extra safety precaution.

damage.

3. The round brush will become hot during use. Do not allow the cord to come

AT ONCE STOP USING the appliance if visible damage occurs or if the equipment

into contact with the round brush during use.

stops functioning or functions off and on.

4. The openings for air inlet and outlet must never become stopped up. Should

STORAGE

the air flow be interrupted during use, by mistake, the built-in safety fuse will

When not in use, the appliance should be disconnected from the mains and

automatically cut off the equipment. The curler will be automatically reconne-

stored in a dry, safe place out of reach for children.

cted after having cooled down for a few minutes.