Melissa 630-010: MEMORY FUNCTION SETTING DATE AND TIME
MEMORY FUNCTION SETTING DATE AND TIME: Melissa 630-010
Table of contents
- INTRODUCTION KNOWLEDGE ABOUT BLOOD PRESSURE QUESTIONS AND ANSWERS ON BLOOD PRESSURE The Brain The Heart CLASSIFICATION OF BLOOD PRESSURE The Kidneys
- How do you take a correct measurement of the blood IMPORTANT SAFEGUARDS pressure ? Are there any symptoms related to high blood pressure ? Which conditions are affecting the blood pressure ? Can you avoid / prevent high blood pressure ?
- CORRECT METHOD OF MEASUREMENT LIST OF COMPONENTS
- DESCRIPTION OF DISPLAY MARKS Applying the waste cuff: PREPARATION BEFORE TAKING A MEASUREMENT TAKING A MEASUREMENT
- MEMORY FUNCTION SETTING DATE AND TIME
- ERROR INDICATORS ENVIRONMENTAL TIP THE WARRENTY DO NOT COVER CARE AND MAINTENANCE
- IMPORTER
shown alternately.
MEMORY FUNCTION
- To end a measurement for any reason, just press Start/Stop but-
- When a valid measurement is made, the reading data will be sto-
ton to turn off the unit and release the cuff pressure.
red with data and time into the Memory automatically as soon as
- If during a measurement the power drops to an insufficient level,
the unit is turned off, automatically shuts off, or when another
the unit will end the measurement and display the low battery
measurement is initiated
symbol.
- To recall your last readings, press the memory button, the memo-
- Replace the batteries and repeat the measurement.
ry number will appear in the upper right hand corner of the dis-
- If the monitor is unable to measure a pulse it will end the measu-
play.
rement attempt. Wait a few minutes make sure that the cuff is
- Less memory number represents the newer reading. Up to 30
positioned properly, and try again.
previous readings can be recalled.
- The display automatically turns off after 3 minutes.
When "No:A" appears in display will the represents average
value of your systolic, diastolic be shown. The blood pressure
SETTING DATE AND TIME
reading and pulse will then be displayed alternately. These rea-
- To be able to save subsequent measurement with correct date
dings are based on the current readings in the memory.
and time, you have to set date and time after proper battery
- By pressing the Start/Stop button at any time you would stop
installation or replacement.
your memory recall and the display will return to normal time/date
- After the batteries have been installed "0:00" and "1 – 1" on the
display.
display.
- Press the Mode button, the individual figures will start to flash.
- When the figure you wish to change is flashing, press the Set
button to change it.
- To continue to the next figure, press the Mode button, the next
figure starts to flash. Be aware that when setting the date, the
month is on the left and the date is on the right.
- When the date and time has been installed, press the Start/Stop
button to end the setting procedure.
44
MS-900VX IM new 01/10/03 9:54 Side 44 (Sort/Process Black plade)
