Melissa 630-010: DESCRIPTION OF DISPLAY MARKS Applying the waste cuff: PREPARATION BEFORE TAKING A MEASUREMENT TAKING A MEASUREMENT

DESCRIPTION OF DISPLAY MARKS

Applying the waste cuff:

- With your palm side up, center monitor on your wrist and apply

Deflating

the cuff so that the cuff’s edge should be approximately 1 cm

Inflating

from your palm.

Measurement error

- Do not apply wrist unit on top of a shirt sleeve.

Measuring

Low battery

PREPARATION BEFORE TAKING A MEASUREMENT

Battery installation:

- Pull off the battery cover in the

same direction as the arrows

- Wrap the cuff snugly around your wrist and attach using the

are pointing.

fastener. The top and bottom edges of the cuff should be tighten-

- Install 2 pcs. alkaline AAA bat-

ded evenly around your wrist.

teries, noting the proper orien-

- Any gab between the wrist and cuff will affect the result of the

tation of positive and negative

measurement.

terminals of the batteries in the

- The fabric cuff can be folded down for ease of viewing the dis-

battery compartment.

play.

- Replace the battery cover.

TAKING A MEASUREMENT

- If the low battery symbol

- After the cuff has been properly placed on either the right or left

appears on the display replace

wrist, press the Start/Stop button. All symbols on the display will

both batteries.

appear.

- It is recommended that you

- After the display reads "0" the "Fuzzy Logic function will auto-

use Alkaline batteries since

matically inflate to an approximate pressure and will then begin to

they are functioning for a lon-

slowly deflate as it takes the measurement. When the measure-

ger period of time.

ment is done the heart symbol will be shown on the display and

- Remove the batteries if the unit is not being used for a long peri-

the systolic and diastolic values be shown in the display after 5

od of time.

sec. will the pulse be shown in the display. Now will the values be

43