Fein SCT5-40M магазин: Cleaning and care.

10

9 01 04 007 01 0

en

Inserting the screw strip (5).

➤

Push the screw strip (5) through the 

screw strip guide (b).

➤

Guide the screw strip (5) over the 

tooth points of the notched discs on 

the sliding piece.

➤

Push the screw strip (5) forwards. The 

first screw must be positioned in a 

groove in front of the centre point of 

the screw stop (4).

➤

To remove the screw strip (5) pull it 

out upwards.

Setting the magazine holder to the 

length of the screw (4).

The magazine holder must be set to the 

respective length of the screw.

➤

Turn the grooved knob on the screw 

stop until the point of the screw and 

inner edge of the screw stop are flush. 

Please observe the measuring scale on 

the screw stop.

Setting the screwdriving depth (3).

The required screwdriving 

depth can be obtained by 

adjusting the grooved knob (3).

Upwards adjustment:

If the screwdriving depth is greater, the 

screw head sinks further into the work 

piece.

Downwards adjustment:

If the screwdriving depth is less deep, the 

screw head will not sink as far into the 

work piece.

The required screwdriving depth will 

depend on the material to be treated and 

is obtained by trial and error.

Operating instructions.

Before screwdriving work check the 

direction of rotation of the drive 

machine. The magazine holder may only 

be operated in the position “Clockwise 

rotation”.

Always hold the drive machine at 

right angles to the work piece.

➤

Switch the drive machine on, lock the 

ON/OFF-switch and position the 

screw stop (4) on the position to be 

fixed.

➤

Using an even pressure, press against 

the surface of the work piece until the 

screw is inserted. The next screw is 

automatically brought into its working 

position.

➤

Lift the drive machine from the work 

piece.

Any screws that have already been 

inserted cannot be taken out again or 

tightened using the magazine holder.

Cleaning and care.

Risk of injury

by switching the tool ON unintentionally.

Before cleaning, pull out the mains plug.

Weekly cleaning (6).

➤

Removing the screw strip.

➤

Press the release knob (2). At the same 

time, hold the sliding piece (c) tightly 

so that the spring does not press it out.

!

3 41 01 083 06 0.book  Seite 10  Dienstag, 26. Februar 2008  3:02 15