Melissa 631-038: INTRODUCTION SAFETY INSTRUCTIONS INSERTING BATTERIES BEFORE STARTING TO USE START TO USE SIMPLE WEIGHING FUNCTION MAINTENANCE: REPLACEMENT OF BATTERY

HCB-FB IM_rev 15/12/04 8:37 Side 10

UK

Please note: When batteries are being inserted/replaced, the scale will in some cases

display a figure – e.g. 2.1 kg. This figure will flash in the display for a short time, after

which the display will read "Err" and switch off. This is not an error, but simply the scale

recalibrating itself. The scale will then be ready for use.

INTRODUCTION

Please read this instruction manual carefully and familiarise yourself with your new scale

before using it the first time. Please retain this manual for future reference.

SAFETY INSTRUCTIONS

Read all instructions before using.

Use this appliance only for its intended use as described in this manual.

In order to prevent interference; do not use the device near equipment with strong electrical

field. Keep the device at a sufficient distance from such equipment or turn them off when

using.

The scale is slippery when wet.

SAVE THESE INSTRUCTIONS

INSERTING BATTERIES

Open the battery compartment on the back of the device.

Insert the Batteries in the battery holder.

BEFORE STARTING TO USE

To calibrate the scale press central of the platform once (about 1 sec) and release to activate

the calibration. When "0.0" disappear from the display the scale is ready for use

Please ajust the weighing mode switch located on the bottom of the scale to set your

weighing unit.

You must choose between: kg./ Lb./St.

START TO USE

Activate the scale by tapping it or giving it a push. the scale will automatically turn on and

start weighing. As soon as the display shows 0,0 the scale is ready for use.

Keep still as possibly, after about 3 sec. your weight will be displayed in your selected

mode.

The scale automatically turns off. 10 secs. after the user has stepped off the scale.

SIMPLE WEIGHING FUNCTION

Activate the scale as mentioned earlier. Place your feet on the scale without leaning to a

side. The display will be locked when you stably stand on the scale.

The display will show the weight when the measurement has been locked. The weight will

be shown for 6 seconds. You must step down from the scale and restart when used

repentantly.

If the scale is activated but not loaded the digits will disappear after 8 seconds.

MAINTENANCE:

Do not overload the scale max. 150 kg./100 g. interval. Do not shock the scale with sudden

loading or striking.

Keep the scale in a warm and dry place.

REPLACEMENT OF BATTERY

It will display "LO" when the power is low. Please open the battery compartment and

replace the batteries as described above.

10