Hotpoint-Ariston MBL 1923 F: Maintenance and care

Maintenance and care: Hotpoint-Ariston MBL 1923 F

Maintenance and care

Switching the appliance off

Replacing the l Odour filter

GB

The filter should be replaced after approximately 6-8

During cleaning and maintenance it is necessary to

months from when it is activated. This period may vary

disconnect the appliance from the electricity supply:

depending on the type of food that is stored. For

information on where a replacement filter may be

1. set the FREEZER OPERATION knob on

purchased, contact Assistance (see Assistance). To

replace the filter, follow the instructions (see diagrams A

2. pull the plug out of the socket

and B).

A

B

! If this procedure is not followed, the alarm may sound.

This alarm does not indicate a malfunction. To restore

normal operation, it is sufficient to set the FREEZER

OPERATION knob on the desired value. To disconnect the

appliance, follow point 1 and 2.

Cleaning the appliance

Holiday function

The external and internal parts, as well as the rubber

seals may be cleaned using a sponge that has been

To minimise energy usage when on holiday, it is not

soaked in lukewarm water and bicarbonate of soda or

necessary to switch the appliance off. The appliance has a

neutral soap. Do not use solvents, abrasive products,

function which allows it to maintain the temperature of the

bleach or ammonia.

refrigerator compartment at approximately 15°C (which

can also be used to conserve make-up and beauty

The removable accessories may be soaked in warm

products). The freezer temperature must be set to the

water and soap or dishwashing liquid. Rinse and dry

minimum value in order to preserve the food.

them carefully.

To enable the function: set the REFRIGERATOR

OPERATION knob on

.

The back of the appliance may collect dust which can

A double acoustic signal informs you when it has been

be removed by delicately using the hose of a vacuum

enabled. A single acoustic signal informs you when it has

cleaner set on medium power. The appliance must be

been disabled.

switched off and the plug must be pulled out before

cleaning the appliance.

Replacing the light bulb

Avoiding mould and unpleasant odours

To replace the light bulb in the refrigerator compartment,

pull out the plug from the

The appliance is manufactured with hygienic materials

electrical socket. Follow the

which are odour free. In order to maintain an odour free

instructions below.

refrigerator and to prevent the formation of stains, food

Access the light bulb by removing

must always be covered or sealed properly.

the cover as indicated in the

diagram.

If you want to switch the appliance off for an extended

Replace it with a similar light bulb

period of time, clean the inside and leave the doors

within the power range indicated

open.

on the cover (15W or 25W).

17