Fein AStxe649_1: en

14

en

Using the recommended clamping devices.

Clamping device 9 07 02 001 00 1

For pipes with a diameter of up to 150 mm use clamping 

device 9 07 02 001 00 1.

– Position the clamping chain (14) around the work 

piece and insert the hooks of fish plate (7) in the 

clamping chain (14).

– Tension the chain using gripping arm (6).

– Mount the pneumatic tool onto the supporting 

bolt (20) (see “Mounting the clamping device”).

The clamping head (19) can be adjusted to the sawing 

cuts and can be pivoted.

Clamping device 9 07 02 004 00 6

For large pipes with a diameter of 150 mm to 325 mm 

use the clamping device 9 07 02 004 00 6 and saw blades 

with a length of 500 mm or 600 mm and a thickness of 

2 mm. Using the chain extension, larger pipes can also be 

machined with a diameter of 440 mm.

Saw-blade guide 9 06 06 002 00 9

For operations using a saw blade with a thickness of 

1.6 mm and a length of 530 mm use the saw-blade guide 

9 06 06 002 00 9.

– With the auxiliary handle removed, fasten the saw-

blade guide at the drill hole on the gear head of the 

power tool.

Clamping device 9 07 02 003 00 8

For machining profiled sections with a width of 290 mm 

and a height of 550 mm, use clamping device 

9 07 02 003 00 8. The design is equivalent to that of a 

parallel vise. The clamping jaws (10+11) and the clamp-

ing head (19) are adjustable.

Clamping device 9 07 02 005 00 0 (without figure)

For cutting pipes and round materials with an external 

diameter of 80 mm to 400 mm, use the clamping/feeding 

device 9 07 02 005 00 0 as a guide for the hacksaw. By 

means of a slipping coupling, the pressing-on time of the 

saw blade is limited and thus the service life is longer. For 

handling, see the Instruction Manual 3 41 00 898 06 6.

Free hand rest 3 27 14 062 02 3

For sawing materials such as corrugated metal, for exam-

ple, use the free hand rest 3 27 14 062 02 3. Disconnect 

the auxiliary handle and fasten the free hand rest to the 

stroke mechanism and in the drill hole on the top of the 

gear head.

Repair and customer service.

Blow out the interior of the power tool at 

regular intervals from outside through the air 

vents with dry, compressed air.

If the supply cord of this power tool is damaged it must 

be replaced by a specially prepared cord available 

through the FEIN customer service centre.

If required, you can change the following parts yourself:

Application tools, auxiliary handle

Warranty and liability.

The warranty for the product is valid in accordance with 

the legal regulations in the country where it is marketed. 

In addition, FEIN also provides a guarantee in accordance 

with the FEIN manufacturer’s warranty declaration.

Only part of the accessories described or shown in this 

instruction manual will be included with your power 

tool.

Declaration of conformity.

FEIN declares itself solely responsible for this product 

conforming with the documents and standards given on 

the last page of this Instruction Manual.

Environmental protection, disposal.

Packaging, worn out power tools and accessories should 

be sorted for environment-friendly recycling.

3 41 01 081 06 0.book  Seite 14  Freitag, 1. August 2008  8:37 08