Fein RS 12-70E: Cleaning and care.

RS 12-70 E

11

EN

Carry out a test run for approx. 20 sec-

onds when using a new sanding belt. Push 

the swiveling extension arm (b) firmly 

outwards to tension the sanding belt 

ready for use.

Cleaning and care.

Risk of injury

by switching the tool ON unintentionally.

Before cleaning, pull out the mains plug.

Carry out the following once a week, or 

more often if the power tool is used more 

frequently:

■

Clean and lubricate the joint and the 

surface of the tension spring on the 

swiveling extension arm.

■

Clean the venting openings.

■

Blow out the motor space from outside 

with dry compressed air.

Maintenance and repairs.

Risk of injury

Service, testing and repairs may only be car-

ried out by electrical engineers in conformity 

with the regulations valid in the respective 

country.

Maintenance and repairs.

We recommend our customer service 

department (repair centre), FEIN author-

ised service centres and agencies. 

Addresses can be found at the end of 

these operating instructions and in the 

enclosed safety instructions.

Please hand these operating instructions 

to the repair centre. An overview of spare 

parts can be found at the end of these 

operating instructions.

Only use original FEIN spare parts.

Spare parts.

The overview of spare parts is at the end 

of these operating instructions. Quoting 

the parts no. (1), reference no. (2) as well 

as the number of spare parts (3) facilitates 

the ordering procedure.

Accessories.

Illustrations and reference numbers can be 

found at the end of these instructions.

Description of the accessories:

A Sanding belt, pack of 10.

B Fleece belt, pack of 5.

C Pre-polishing cream, 200 ml.

D Final polishing cream, 200 ml.

E Polishing belt, pack of 3.

F Idlers of Ø 35 mm, for working in 

places difficult to access.

G Basic set, each consisting of 10 sanding 

belts 20 x 815 mm, grain 120, 

20 x 815 mm, grain 180, 

40 x 815 mm, grain 120, 

40 x 815 mm, grain 180 and 5 fleece 

belts 20 x 815 mm, grain 280.

H Polishing set, each consisting of 

10 sanding belts 20 x 815 mm, 

grain 320 and 20 x 815 mm, 

grain 400, and each with 1 tube of 

pre-polishing cream and final polishing 

cream and 3 polishing belts 

20 x 815 mm.

I

Metal carry case

(690 x 240 x 160 mm).

When using application tools other than 

those listed here, the user must check 

whether additional protective measures 

have to be taken.

!

!

3 41 01 043 06 7 - Buch  Seite 11  Mittwoch, 4. Februar 2004  11:07 11