Fein ASzx-648-1: en

17

en

An estimation of the level of exposure to vibration 

should also take into account the times when the tool is 

switched off or when it is running but not actually doing 

the job. This may significantly reduce the exposure level 

over the total working period.

Identify additional safety measures to protect the opera-

tor from the effects of vibration such as: maintain the tool 

and the accessories, keep the hands warm, organisation 

of work patterns.

Operating instructions.

Before assembling, degrease the drive spindle and the 

internal taper of the drill chuck.

Adjust the gear setting only when the machine is at a 

complete stop.

For stationary use in a drill stand, remove the switched 

off power tool from the drill stand every 50 operating 

hours while at normal running temperature. Then, turn 

the machine around by 180° and run it for approx. 

1 minute to achieve uniform lubrication.

Repair and customer service.

When working metal under extreme operat-

ing conditions, it is possible for conductive 

dust to settle in the interior of the power 

tool. The total insulation of the power tool can be 

impaired. Blow out the interior of the power tool via the 

ventilation slots frequently with dry and oil-free com-

pressed air, and connect a residual current device (RCD) 

on the line side.

ASzx 648-1: Lubricate the output shaft at the lubri-

cating nipple each month, or even more often in 

case of frequent usage and heavy loading.

If the supply cord of this power tool is damaged it must 

be replaced by a specially prepared cord available 

through the FEIN customer service centre.

If required, you can change the following parts yourself:

drill chuck, application tools, auxiliary handle

Warranty and liability.

The warranty for the product is valid in accordance with 

the legal regulations in the country where it is marketed. 

In addition, FEIN also provides a guarantee in accordance 

with the FEIN manufacturer’s warranty declaration.

The delivery scope of your power tool may include only 

a part of the accessories described or shown in this 

instruction manual.

Declaration of conformity.

FEIN declares itself solely responsible for this product 

conforming with the relevant provisions given on the last 

page of this Instruction Manual.

Environmental protection, disposal.

Packaging, worn out power tools and accessories should 

be sorted for environment-friendly recycling.

3 41 01 089 06 0.book  Seite 17  Freitag, 25. Juni 2010  8:07 08