Delonghi KD-M260 Glass: инструкция

GB

COOKER HOOD - User instructions

CZ

ODSAVAČ PAR-Návod k použití

DK

EMHÆTTE - Brugervejledning

FIN

LIESITUULETIN - Käyttöohje

GR

ΑΠΟΡΡΟΦΗΤΗΡΑΣ ΣΕ ΕΚΟΣΗ ΑΠΟΡΡΟΦΗΣΗΣ - Εγχειρίδιο χρήση

H

ELSZÍVÓ KÜRTŐ - Használati utasítás

N

AVTREKKSKAPPE - Bruksanvisning

PL

OKAP ZASYSAJĄCY - Instrukcja obsługi

R

HOTĂ ASPIRANTĂ - Manual de utilizare

RUS

  -  

S

SPISKÅPA - Bruksanvisning

M

max 90 cm

Fig.1

20

235

Fig.2 Fig.3

Fig.4

Fig.5

- 3 -

A

B

Fig.6

C

Fig.8 Fig.7

Fig.9

Fig.10

- 4 -

A

B

Fig.12Fig.11

A

B

C

Fig.13 Fig.14

Fig.15

- 5 -

The symbol on the product or on the accompanying

GB

ENGLISH

paperwork indicates that the appliance should not be

treated as domestic waste, but should be delivered to

a suitable electric and electronic appliance recycling collection

GENERAL

point. Follow local guidelines when disposing of waste. For

more information on the treatment, re-use and recycling of

Carefully read the following important information regarding

this product, please contact your local authority, domestic

installation safety and maintenance. Keep this information

waste collection service or the shop where the appliance was

booklet accessible for further consultations. The appliance

purchased.

has been designed for use in the ducting version (air exhaust

to the outside - Fig.1B), filtering version (air circulation on the

INSTALLATION INSTRUCTIONS

inside - Fig.1A) or with external motor (Fig.1C).

•Assemblyandelectricalconnectionsmustbecarriedout

SAFETY PRECAUTION

by specialised personnel.

•Wearprotectiveglovesbeforeproceedingwiththe

1. Take care when the cooker hood is operating simultaneously

installation.

with an open fireplace or burner that depend on the air in the

environment and are supplied by other than electrical energy,

•ElectricConnection:

as the cooker hood removes the air from the environment

Note! Verify the data label placed inside the appliance:

which a burner or fireplace need for combustion. The negative

- If the symbol

appears on the plate, it means that no earth

pressure in the environment must not exceed 4Pa (4x10-5 bar).

connection must be made on the appliance, therefore follow

Provide adequate ventilation in the environment for a safe

the instructions concerning insulation class II.

operation of the cooker hood. Follow the local laws applicable

- If the symbol DOES NOT appear on the plate, follow the

for external air evacuation.

instructions concerning insulation class I.

Before connecting the model to the electricity network:

Insulation class II

- Control the data plate (positioned inside the appliance)

- The appliance has been manufactured as a class II, therefore

to ascertain that the voltage and power correspond to the

no earth cable is necessary. The plug must be easily accessible

network and the socket is suitable. If in doubt ask a qualified

after the installation of the appliance. If the appliance

electrician.

is equipped with power cord without plug, a suitably

- If the power supply cable is damaged, it must be replaced with

dimensioned omnipolar switch with 3 mm minimum opening

another cable or a special assembly, which may be obtained

between contacts must be fitted between the appliance and

direct from the manufacturer or from the Technical Assistance

the electricity supply in compliance with the load and current

Centre.

regulations.

- This device must be connected to the supply network through

- The connection to the mains is carried out as follows:

either a plug fused 3A or hardwired to a 2 fase spur protected

BROWN = L line

by 3A fuse.

BLUE = N neutral.

2. Warning!

Insulation class I

In certain circumstances electrical appliances may be a

This is a class I, appliance and must therefore be connected to

danger hazard.

an effiecient earthing system.

A) Do not check the status of the filters while the cooker

- The appliance must be connected to the electricity supply as

hood is operating.

follows:

B) Do not touch bulbs or adjacent areas, during or straight

BROWN = L line

after prolonged use of the lighting installation.

BLUE = N neutral

C) Flambè cooking is prohibited underneath the cooker

YELLOW/GREEN = earth.

hood.

The neutral wire must be connected to the terminal with the

D) Avoid free flame, as it is damaging for the filters and a

N symbol while the YELLOW/GREEN, wire must be connected

fire hazard.

to the terminal by the earth symbol .

E) Constantly check food frying to avoid that the

When connecting the appliance to the electricity supply, make

overheated oil may become a fire hazard.

sure that the mains socket has an earth connection. After fitting

F) Disconnect the electrical plug prior to any maintenance.

the ducted cooker hood, make sure that the electrical plug is

G) This appliance is not intended for use by young children

in a position where it can be accessed easily. If the appliance

or infirm persons without supervision.

is connected directly to the electricity supply, an omnipolar

H) Young children should be supervised to ensure they do

switch with a minimum contact opening of 3 mm must be

not play with the appliance.

placed in between the two; its size must be suitable for the

I) There shall be adequate ventilation of the room when

load required and it must comply with current legislation.

the rangehood is used at the same time as appliances

burning gas or other fuels.

•If the hob is electric, gas, or induction, the minimum distance

L) There is a risk of fire if cleaning is not carried out in

between the same and the lower part of the hood must be at

accordance with the instructions.

least 65 cm. If a connection tube composed of two parts is

used, the upper part must be placed outside the lower part. Do

This appliance conforms to the European Directive EC/2002/96,

not connect the cooker hood exhaust to the same conductor

Waste Electrical and Electronic Equipment (WEEE). By making

used to circulate hot air or for evacuating fumes from other

sure that this appliance is disposed of in a suitable manner,

appliances generated by other than an electrical source. Before

the user is helping to prevent potential damage to the

proceeding with the assembly operations, remove the anti-

environment or to public health.

grease filter(s) (Fig.7A) so that the unit is easier to handle.

- 6 -

- In the case of assembly of the appliance in the suction version

non-abrasive neutral liquid detergents or in the dishwasher

prepare the hole for evacuation of the air.

at low temperatures and on short cycles.

- After a few washes, colour alterations may occur. This does

•We recommend the use of an air exhaust tube which has the

not give the right to claim their replacement.

same diameter as the air exhaust outlet hole. If a pipe with a

•Theactivecarbonfilters are used to purify the air that is

smaller diameter is used, the efficiency of the product may be

sent back into the room and its function is to mitigate the

reduced and its operation may become noisier.

unpleasant odours produced by cooking.

- The non-regenerable active carbon filters must be replaced

•Fixingtothewall:

at least every 4 months. The saturation of the active charcoal

- Drill the holes A respecting the distances indicated (Fig.2).

depends on the more or less prolonged use of the appliance,

- Fix the appliance to the wall and align it in horizontal position

on the type of kitchen and on the frequency with which anti-

to the wall units.

grease filter is cleaned.

- When the appliance has been adjusted, definitely fix the hood

- Regenerable active charcoal filters must be washed by hand,

using the screws A (Fig.5).

with non abrasive neutral detergents, or in the dishwasher at

For the various installations use screws and screw anchors

a maximum temperature of 65°C (the washing cycle must be

suited to the type of wall (e.g. reinforced concrete, plasterboard,

complete without dishware). Remove excess water without

etc.). If the screws and screw anchors are provided with the

damaging the filter, remove the plastic parts, and let the

product, check that they are suitable for the type of wall on

mat dry in the oven for at least 15 minutes approximately at

which the hood is to be fixed.

a maximum temperature of 100°C. To keep the regenerable

charcoal filter functioning efficient this operation must be

•Fixingthedecorativetelescopicflue:

repeated every 2 months. These must be replaced at least

- Arrange the electrical power supply within the dimensions

every 3 years or when the mat is damaged.

of the decorative flue. If your appliance is to be installed in the

•Beforeremountingtheanti-greasefiltersandthe

ducting version or in the version with external motor, prepare

regenerable active charcoal filters it is important that they

the air exhaust opening.

are completely dry.

- Adjust the width of the support bracket of the upper flue

•Cleanthehoodfrequently,bothinternallyandexternally,

(Fig.3).

using a cloth dampened with denatured alcohol or neutral

- Then fix it to the ceiling using the screws A (Fig.3) in such a

liquid detergents that are non abrasive.

way that it is in line with your hood and respecting the distance

•The lighting .system is designed for use during cooking

from the ceiling indicated in Fig.2.

and not for the prolonged general lighting of the room. The

- Connect the flange C to the air exhaust hole using a

prolonged use of the lighting system significantly decreases

connection pipe (Fig.5).

the average duration of the bulbs.

- Insert the upper flue into the lower flue.

•If the appliance is equipped with courtesy lights it is possible

- Fix the lower flue to the hood using the screws B provided

to use them for general room lighting for a prolonged amount

(Fig.5), extract the upper flue up to the bracket and fix it with

of time.

the screws B (Fig.3).

•Attention: the non compliance with the hood cleaning

- If your appliance has the lower connections indicated as in

warnings and with the replacement and cleaning of the filters

Fig.4A, the fixing to be carried out is that shown in Fig.6A.

entails risk of fires. One therefore recommends keeping to the

To transform the hood from a ducting version into a filtering

suggested instructions.

version, ask your dealer for the charcoal filters and follow the

installation instructions.

•Replacinghalogenlightbulbs(Fig.8):

In order to replace the dichroic lamps, carefully remove

•Filterhood:

the lamp from the lamp holder with the help of a small flat

Please note:

screwdriver or a similar tool. PLEASE NOTE! In doing this

- In order to transform the hood from EXTRACTOR HOOD

operation, please take care not to scratch the hood. Replace

into FILTER HOOD the carbon filters must be ordered at your

the bulbs with new ones of the same type.

distributor as accessory. We have two different types of Kit,

one with non-regenerable active carbon filters (Fig.7B) and the

•Replacinghalogenlightbulbs(Fig.9):

other one with regenerable active charcoal filters (washable)

To replace the halogen light bulbs B, remove the glass pane

(Fig.7C).

C using a lever action on the relevant cracks. Replace the bulbs

- To replace the non-regenerable active carbon filters X, pull

with new ones of the same type. Caution: do not touch the

lever outwards as shown in Fig.7B.

light bulb with bare hands.

USE AND MAINTENANCE

•ReplacingLEDlamps(Fig.10):

If the appliance version is with LED lamps, the intervention of

•We recommend that the cooker hood is switched on before

a specialised technician is necessary to replace them.

any food is cooked. We also recommend that the appliance is

left running for 15 minutes after the food is cooked, in order

•Replacingthehalogen/incandescentlamps(Fig.11):

to thoroughly eliminate all contaminated air. The effective

Only use lamps of the same type and Wattage installed on

performance of the cooker hood depends on constant

the device.

maintenance; the anti-grease filter and the active carbon filter

both require special attention.

•Commandsluminous (Fig.12.A.B.) the key symbols are

•Theanti-greasefilter is responsible retaining the grease

explained below:

particles suspended in the air, therefore it is subject to clogging

A = LIGHT

with variable frequency according to the use of the appliance.

B = OFF

- To prevent the danger of possible fires, at least every 2

C = SPEED I

months one must wash the anti-grease filters by hand using

D = SPEED II

- 7 -