Delonghi KD-PL60 X: инструкция
Раздел: Бытовая, кухонная техника, электроника и оборудование
Тип: Вытяжка
Характеристики, спецификации
Инструкция к Вытяжке Delonghi KD-PL60 X
GB
COOKER HOOD - User instructions
CZ
ODSAVAČ PAR-Návod k použití
DK
EMHÆTTE - Brugervejledning
FIN
LIESITUULETIN - Käyttöohje
GR
ΑΠΟΡΡΟΦΗΤΗΡΑΣ ΣΕ ΕΚΟΣΗ ΑΠΟΡΡΟΦΗΣΗΣ - Εγχειρίδιο χρήση
H
ELSZÍVÓ KÜRTŐ - Használati utasítás
N
AVTREKKSKAPPE - Bruksanvisning
PL
OKAP ZASYSAJĄCY - Instrukcja obsługi
R
HOTĂ ASPIRANTĂ - Manual de utilizare
RUS
-
S
SPISKÅPA - Bruksanvisning
M
max 90 cm
Fig.1
20
235
Fig.2 Fig.3
Fig.4
Fig.5
- 3 -
A
B
Fig.6
C
Fig.8 Fig.7
Fig.9
Fig.10
- 4 -
A
B
Fig.12Fig.11
A
B
C
Fig.13 Fig.14
Fig.15
- 5 -
The symbol on the product or on the accompanying
GB
ENGLISH
paperwork indicates that the appliance should not be
treated as domestic waste, but should be delivered to
a suitable electric and electronic appliance recycling collection
GENERAL
point. Follow local guidelines when disposing of waste. For
more information on the treatment, re-use and recycling of
Carefully read the following important information regarding
this product, please contact your local authority, domestic
installation safety and maintenance. Keep this information
waste collection service or the shop where the appliance was
booklet accessible for further consultations. The appliance
purchased.
has been designed for use in the ducting version (air exhaust
to the outside - Fig.1B), filtering version (air circulation on the
INSTALLATION INSTRUCTIONS
inside - Fig.1A) or with external motor (Fig.1C).
•Assemblyandelectricalconnectionsmustbecarriedout
SAFETY PRECAUTION
by specialised personnel.
•Wearprotectiveglovesbeforeproceedingwiththe
1. Take care when the cooker hood is operating simultaneously
installation.
with an open fireplace or burner that depend on the air in the
environment and are supplied by other than electrical energy,
•ElectricConnection:
as the cooker hood removes the air from the environment
Note! Verify the data label placed inside the appliance:
which a burner or fireplace need for combustion. The negative
- If the symbol
appears on the plate, it means that no earth
pressure in the environment must not exceed 4Pa (4x10-5 bar).
connection must be made on the appliance, therefore follow
Provide adequate ventilation in the environment for a safe
the instructions concerning insulation class II.
operation of the cooker hood. Follow the local laws applicable
- If the symbol DOES NOT appear on the plate, follow the
for external air evacuation.
instructions concerning insulation class I.
Before connecting the model to the electricity network:
Insulation class II
- Control the data plate (positioned inside the appliance)
- The appliance has been manufactured as a class II, therefore
to ascertain that the voltage and power correspond to the
no earth cable is necessary. The plug must be easily accessible
network and the socket is suitable. If in doubt ask a qualified
after the installation of the appliance. If the appliance
electrician.
is equipped with power cord without plug, a suitably
- If the power supply cable is damaged, it must be replaced with
dimensioned omnipolar switch with 3 mm minimum opening
another cable or a special assembly, which may be obtained
between contacts must be fitted between the appliance and
direct from the manufacturer or from the Technical Assistance
the electricity supply in compliance with the load and current
Centre.
regulations.
- This device must be connected to the supply network through
- The connection to the mains is carried out as follows:
either a plug fused 3A or hardwired to a 2 fase spur protected
BROWN = L line
by 3A fuse.
BLUE = N neutral.
2. Warning!
Insulation class I
In certain circumstances electrical appliances may be a
This is a class I, appliance and must therefore be connected to
danger hazard.
an effiecient earthing system.
A) Do not check the status of the filters while the cooker
- The appliance must be connected to the electricity supply as
hood is operating.
follows:
B) Do not touch bulbs or adjacent areas, during or straight
BROWN = L line
after prolonged use of the lighting installation.
BLUE = N neutral
C) Flambè cooking is prohibited underneath the cooker
YELLOW/GREEN = earth.
hood.
The neutral wire must be connected to the terminal with the
D) Avoid free flame, as it is damaging for the filters and a
N symbol while the YELLOW/GREEN, wire must be connected
fire hazard.
to the terminal by the earth symbol .
E) Constantly check food frying to avoid that the
When connecting the appliance to the electricity supply, make
overheated oil may become a fire hazard.
sure that the mains socket has an earth connection. After fitting
F) Disconnect the electrical plug prior to any maintenance.
the ducted cooker hood, make sure that the electrical plug is
G) This appliance is not intended for use by young children
in a position where it can be accessed easily. If the appliance
or infirm persons without supervision.
is connected directly to the electricity supply, an omnipolar
H) Young children should be supervised to ensure they do
switch with a minimum contact opening of 3 mm must be
not play with the appliance.
placed in between the two; its size must be suitable for the
I) There shall be adequate ventilation of the room when
load required and it must comply with current legislation.
the rangehood is used at the same time as appliances
burning gas or other fuels.
•If the hob is electric, gas, or induction, the minimum distance
L) There is a risk of fire if cleaning is not carried out in
between the same and the lower part of the hood must be at
accordance with the instructions.
least 65 cm. If a connection tube composed of two parts is
used, the upper part must be placed outside the lower part. Do
This appliance conforms to the European Directive EC/2002/96,
not connect the cooker hood exhaust to the same conductor
Waste Electrical and Electronic Equipment (WEEE). By making
used to circulate hot air or for evacuating fumes from other
sure that this appliance is disposed of in a suitable manner,
appliances generated by other than an electrical source. Before
the user is helping to prevent potential damage to the
proceeding with the assembly operations, remove the anti-
environment or to public health.
grease filter(s) (Fig.7A) so that the unit is easier to handle.
- 6 -
- In the case of assembly of the appliance in the suction version
non-abrasive neutral liquid detergents or in the dishwasher
prepare the hole for evacuation of the air.
at low temperatures and on short cycles.
- After a few washes, colour alterations may occur. This does
•We recommend the use of an air exhaust tube which has the
not give the right to claim their replacement.
same diameter as the air exhaust outlet hole. If a pipe with a
•Theactivecarbonfilters are used to purify the air that is
smaller diameter is used, the efficiency of the product may be
sent back into the room and its function is to mitigate the
reduced and its operation may become noisier.
unpleasant odours produced by cooking.
- The non-regenerable active carbon filters must be replaced
•Fixingtothewall:
at least every 4 months. The saturation of the active charcoal
- Drill the holes A respecting the distances indicated (Fig.2).
depends on the more or less prolonged use of the appliance,
- Fix the appliance to the wall and align it in horizontal position
on the type of kitchen and on the frequency with which anti-
to the wall units.
grease filter is cleaned.
- When the appliance has been adjusted, definitely fix the hood
- Regenerable active charcoal filters must be washed by hand,
using the screws A (Fig.5).
with non abrasive neutral detergents, or in the dishwasher at
For the various installations use screws and screw anchors
a maximum temperature of 65°C (the washing cycle must be
suited to the type of wall (e.g. reinforced concrete, plasterboard,
complete without dishware). Remove excess water without
etc.). If the screws and screw anchors are provided with the
damaging the filter, remove the plastic parts, and let the
product, check that they are suitable for the type of wall on
mat dry in the oven for at least 15 minutes approximately at
which the hood is to be fixed.
a maximum temperature of 100°C. To keep the regenerable
charcoal filter functioning efficient this operation must be
•Fixingthedecorativetelescopicflue:
repeated every 2 months. These must be replaced at least
- Arrange the electrical power supply within the dimensions
every 3 years or when the mat is damaged.
of the decorative flue. If your appliance is to be installed in the
•Beforeremountingtheanti-greasefiltersandthe
ducting version or in the version with external motor, prepare
regenerable active charcoal filters it is important that they
the air exhaust opening.
are completely dry.
- Adjust the width of the support bracket of the upper flue
•Cleanthehoodfrequently,bothinternallyandexternally,
(Fig.3).
using a cloth dampened with denatured alcohol or neutral
- Then fix it to the ceiling using the screws A (Fig.3) in such a
liquid detergents that are non abrasive.
way that it is in line with your hood and respecting the distance
•The lighting .system is designed for use during cooking
from the ceiling indicated in Fig.2.
and not for the prolonged general lighting of the room. The
- Connect the flange C to the air exhaust hole using a
prolonged use of the lighting system significantly decreases
connection pipe (Fig.5).
the average duration of the bulbs.
- Insert the upper flue into the lower flue.
•If the appliance is equipped with courtesy lights it is possible
- Fix the lower flue to the hood using the screws B provided
to use them for general room lighting for a prolonged amount
(Fig.5), extract the upper flue up to the bracket and fix it with
of time.
the screws B (Fig.3).
•Attention: the non compliance with the hood cleaning
- If your appliance has the lower connections indicated as in
warnings and with the replacement and cleaning of the filters
Fig.4A, the fixing to be carried out is that shown in Fig.6A.
entails risk of fires. One therefore recommends keeping to the
To transform the hood from a ducting version into a filtering
suggested instructions.
version, ask your dealer for the charcoal filters and follow the
installation instructions.
•Replacinghalogenlightbulbs(Fig.8):
In order to replace the dichroic lamps, carefully remove
•Filterhood:
the lamp from the lamp holder with the help of a small flat
Please note:
screwdriver or a similar tool. PLEASE NOTE! In doing this
- In order to transform the hood from EXTRACTOR HOOD
operation, please take care not to scratch the hood. Replace
into FILTER HOOD the carbon filters must be ordered at your
the bulbs with new ones of the same type.
distributor as accessory. We have two different types of Kit,
one with non-regenerable active carbon filters (Fig.7B) and the
•Replacinghalogenlightbulbs(Fig.9):
other one with regenerable active charcoal filters (washable)
To replace the halogen light bulbs B, remove the glass pane
(Fig.7C).
C using a lever action on the relevant cracks. Replace the bulbs
- To replace the non-regenerable active carbon filters X, pull
with new ones of the same type. Caution: do not touch the
lever outwards as shown in Fig.7B.
light bulb with bare hands.
USE AND MAINTENANCE
•ReplacingLEDlamps(Fig.10):
If the appliance version is with LED lamps, the intervention of
•We recommend that the cooker hood is switched on before
a specialised technician is necessary to replace them.
any food is cooked. We also recommend that the appliance is
left running for 15 minutes after the food is cooked, in order
•Replacingthehalogen/incandescentlamps(Fig.11):
to thoroughly eliminate all contaminated air. The effective
Only use lamps of the same type and Wattage installed on
performance of the cooker hood depends on constant
the device.
maintenance; the anti-grease filter and the active carbon filter
both require special attention.
•Commandsluminous (Fig.12.A.B.) the key symbols are
•Theanti-greasefilter is responsible retaining the grease
explained below:
particles suspended in the air, therefore it is subject to clogging
A = LIGHT
with variable frequency according to the use of the appliance.
B = OFF
- To prevent the danger of possible fires, at least every 2
C = SPEED I
months one must wash the anti-grease filters by hand using
D = SPEED II
- 7 -