Siemens TE502206RW: Frost protection
Frost protection: Siemens TE502206RW
Table of contents
- Safety instructions
- Table of Contents Included in delivery
- Overview Controls
- Display messages Before using for the rst time
- Switching off the appliance
- Water lter
- Menu settings
- Adjusting the Preparation using grinding unit coffee beans
- Preparation using Preparing milk froth ground coffee Dispensing hot water
- Maintenance and daily cleaning
- Cleaning the milk system
- Cleaning the brewing unit
- Tips on energy saving Service Programmes
- Descaling
- Cleaning Calc‘n‘Clean
- Frost protection
- Accessories Disposal Guarantee Technical data
- Simple troubleshooting Problem Cause Solution
- Problem Cause Solution
deen
N.B.: If the water lter is activated, the
Empty drip tray
display will prompt you to remove the lter
Insert drip tray
and then press the start button (10) again.
● Empty drip tray (8) and replace them.
Remove the lter now if you have not
Replace the lter if one is being used. The
already done so�
appliance has nished cleaning is ready for
Press the start button (10).
use again.
Fill descaler
Important: Wipe down the appliance using
Press start
a soft, damp cloth to immediately remove
● Pour lukewarm water into the empty
any descaler residue. Such residue can
water tank (16) up to the 0,5l mark and
cause corrosion. New sponge cloths may
dissolve 2 Siemens descaling tablets in it�
contain salts. Salts can cause rust lm
● Press the start button (10).
on stainless steel and must therefore be
washed out thoroughly before use
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 10 minutes.
Frost protection
Place container
¡
To avoid damage from low tempera-
Pull milk frother
tures during transport and storage,
● Place a receptacle with a capacity of at
the appliance must be completely
least 1 litre under the outlet.
emptied rst.
● Pull the milk frother (6) to open it.
Note: The appliance must be ready for use
Calc‘n‘Clean in progress
and the water tank (16) lled.
The descaling pro gramme will now run for
1� Place a large receptacle under outlet.
about 12 minutes.
2� Press the
h button (11).
The h button (11) ashes and the
Clean / Fill water tank
appliance now heats up for approx.
Press start
20 seconds. The display then shows
● Rinse the water tank (16) and rell it with
Pull milk frother�
fresh water up to the max mark�
3� Open the milk frother (6) by pulling it out
● Press the start button (10).
and release steam for about 15 seconds.
4� Switch the appliance off at the power
Calc‘n‘Clean in progress
on/off switch O / I (9)�
The descaling pro gramme now runs for
5� Empty the water tank (16) and the drip
about 30 seconds and rinses the appliance.
tray (8)�
Push milk frother
● Push the milk frother (6) in to close it.
Calc‘n‘Clean in progress
The cleaning pro gramme will now run for
about 8 minutes.
18
