Siemens TE502206RW: Descaling
Descaling: Siemens TE502206RW
Table of contents
- Safety instructions
- Table of Contents Included in delivery
- Overview Controls
- Display messages Before using for the rst time
- Switching off the appliance
- Water lter
- Menu settings
- Adjusting the Preparation using grinding unit coffee beans
- Preparation using Preparing milk froth ground coffee Dispensing hot water
- Maintenance and daily cleaning
- Cleaning the milk system
- Cleaning the brewing unit
- Tips on energy saving Service Programmes
- Descaling
- Cleaning Calc‘n‘Clean
- Frost protection
- Accessories Disposal Guarantee Technical data
- Simple troubleshooting Problem Cause Solution
- Problem Cause Solution
deen
Descaling
Place container
Duration: approx. 25 minutes.
Pull milk frother
● Place a receptacle with a capacity of at
Important: If there is a lter in the water
least 0.5 litres under the outlet.
tank (16), it needs to be removed before the
● Pull the milk frother (6) to open it.
descaling programme is run.
Descale in progress
If the message Descale required!
The descaling pro gramme will now run for
appears on the display, press the e off / j
about 12 minutes.
button (12) for 3 seconds and then press
the start button (10). The descaling pro-
Clean / Fill water tank
gramme will start�
Press start
To descale the appliance before being
● Rinse the water tank (16) and rell it with
prompted, press the e off / j button (12) for
fresh water up to the max mark�
at least 3 seconds. Then press the e off / j
● Press the start button (10).
button (12) briey twice. Turn the upper
rotary knob (14) until Start descaling
Descale in progress
appears in the display�
The descaling pro gramme now runs for
To start the descaling procedure, press the
about 30 seconds and rinses the appliance.
start button (10).
The display will guide you through the
Push milk frother
programme�
● Push the milk frother (6) in to close it.
Empty drip tray
Descale in progress
Insert drip tray
The descaling pro gramme now runs for
● Empty drip tray (8) and replace them.
about 1 minute.
Empty drip tray
N.B.: If the water lter is activated, the
Insert drip tray
display will prompt you to remove the
● Empty drip tray (8) and replace them.
lter and then press the start button (10)
Replace the lter if one is being used. The
again. Remove the lter now if you have
appliance has completed descaling and is
not already done so� Press the start button
ready for use again.
(10)�
Important: Wipe down the appliance using
Fill descaler
a soft, damp cloth to immediately remove
Press start
any descaler residue. Such residue can
● Pour lukewarm water into the empty
cause corrosion. New sponge cloths may
water tank (16) up to the 0,5l mark and
contain salts. Salts can cause rust lm
dissolve 2 Siemens descaling tablets in it�
on stainless steel and must therefore be
● Press the start button (10).
washed out thoroughly before use.
Descale in progress
The descaling pro gramme will now run for
about 10 minutes.
16
