Thrustmaster Ferrari Wireless F430 Cockpit: INSTALLING THE WHEEL

INSTALLING THE WHEEL

ADJUSTING THE TILT AND LENGTH

OF THE DRIVING POSITION

- Slightly unscrew (anticlockwise) the 2 clamp screws (1) at the back of the base.

- Adjust the angle of the base’s column (3) so that is suitable to you.

- Then tighten (clockwise) the 2 clamp screws (1).

- Slightly unscrew (anticlockwise) the clamp screw (6) located at the front of the base’s column. Then draw

out the column to the length you require.

- Then tighten (clockwise) the clamp screw (6), taking care that it is correctly inserted into one of the holes

provided for this purpose. You can do this simply by positioning the upper hole by the locating mark

provided for this purpose.

FITTING THE WHEEL TO THE BASE

Lugs (front of the base) Lug notches (back of the wheel)

+

Locking tab (back of the wheel)

- Position the removable wheel (4) horizontally, and then insert the 2 lugs (on the front of the base) into

the 2 lug notches (on the back of the wheel).

- Let the wheel down vertically, and then lock the wheel into position by pressing the locking tab (on the

back of the wheel) then releasing it until you hear a gentle “click”.

- Check that the steering wheel is correctly secured to the base.

- Electronically connect the steering wheel to its base by connecting the elbow-shaped male connector (on

the end of the power cord (5)) to the female connector (to the left of the wheel).

- Rotate the nut (on the end of the connector) clockwise to secure the connection.

PERFORM THE OPERATION IN REVERSE TO

TAKE OFF THE REMOVABLE WHEEL FROM THE BASE

FITTING BATTERIES AND RECOVERING THE RECEIVER

- Remove cover from the battery compartment (8) (located between the 2 pedals) and fit 4 LR6 / AA

batteries, ensuring that the polarities are in the right position.

- Recover the wireless receiver (14) found in the lower section of the battery compartment.

- Fit back the battery compartment’s cover.

SWITCHING THE WHEEL ON OR OFF

- Position the switch (located on the right-hand side of the wheel):

- To ON for switching on the wheel.

- To OFF for switching off the wheel.

Important note:

When you switch on your wheel, it must always be perfectly centred physically (to prevent any

misalignment).