Yamaha BRX-610: Problem Cause Remedy Page

TROUBLESHOOTING

Problem Cause Remedy Page

No picture. Incorrect cable connections. Make sure that the cables are connected correctly.

13

Make sure that the connected TV is set to the correct

13

input.

Connect this unit to the TV with VIDEO jack using

13

the supplied video pin cable.

– If picture is still not displayed with this unit

connected to the VIDEO jack, press and hold

and on the front panel simultaneously

for around 5 seconds when no disc is inserted and

playback is stopped to switch NTSC/PAL.

TV system is set incorrectly. Press and hold and on the front panel

—

simultaneously for around 5 seconds when no disc is

inserted and playback is stopped to switch NTSC/

PAL. Set resolution properly again when connecting

through HDMI (p. 37).

The power is

The sleep timer is set. This is not malfunction. Turn on this unit and play

30

suddenly turned off.

the source again.

[Auto Power Off] is set to [On]. Set [Auto Power Off] to [Off].

35

Sound is heard from

Incorrect cable connections. Connect the cables properly. If the problem persists,

11

the speaker on one

the cables may be defective.

side only.

There is noise

This unit is too close to the digital or

Move this unit farther away from such equipment.

—

interference from

high-frequency equipment.

digital or radio

frequency

equipment.

This unit makes a

These sounds are not malfunctions of this unit but

—

snapping sound

are normal operating conditions.

when starting

playback or loading a

disc.

No sound from the

The subwoofer is not connected properly. Check that the subwoofer is connected properly.

11

subwoofer.

The level of subwoofer is low. Increase the subwoofer level with the SW

7

(subwoofer) + button.

Sound from the

The subwoofer output level from the unit

Decrease the subwoofer output level with the SW

7

subwoofer

is too high.

(subwoofer) - button, then increase the subwoofer

connected to the

level with the control on the subwoofer itself.

INFORMATION

ADDITIONAL

SUBWOOFER pre-

out jack is distorted.

The system settings

When [HDMI Control] is set to [On],

Set [HDMI Control] to [Off] or set the system again

35

change

operations of the TV (for example,

by using its remote control.

automatically.

changing channels, etc.) changes the

system settings.

The HDMI control

[HDMI Control] is set to [Off]. Set [HDMI Control] to [On].

35

function does not

The HDMI control function is disabled

Refer to the manual supplied with your TV and

—

work properly.

on your TV.

check the setting.

The automatic

The TV does not support the automatic

Set [Lip Sync] to [Manual] and then manually adjust

38

lipsync is not

lipsync.

the audio output delay.

effective even [Lip

Sync] is set to [Auto].

English

43 En