Yamaha BRX-610: Audio Setting ■ Audio Output ■ Post Process ■ System Information ■ Speaker Setting

SETUP MENU

3 Press RETURN to go back to speaker selection.

Audio Setting

[2ch Downmix]

The default settings are marked with “

*

You can select down mix method to 2-ch from [Stereo] or

”.

[Lt/Rt].

■ Audio Output

Stereo*, Lt/Rt

[HDMI]

[Test Tone]

You can select the output mode of the HDMI terminal.

You can check if the speaker setting is correct by

Bitstream, PCM, Off

*

outputting the test tone.

[Subwoofer Size]

Notes

You can select the size for your subwoofer speaker to be

[Small] or [Large]. When your subwoofer driver diameter

• To output sound from the speakers, select [Off].

• Sound from your iPod or the audio signal input to the DIGITAL

is more than 20 cm, or when you feel low-frequency and

IN (COAXIAL and OPTICAL) jacks of this unit, cannot be

bass sound is weak, select [Large].

output to a TV from this unit through the HDMI cable.

Small*, Large

• To output HD audio (such as Dolby TrueHD or DTS-HD) from

the HDMI terminal, set [Video Out Select] to [HDMI Auto] or

■ Post Process

more than [HDMI 720p] (p. 37).

[UpMix]

[DRC]

You can multi-channelize the 2-channel audio signal

You can set the DRC (Dynamic Range Compression)

(effective on speaker output). To multi-channelize, select

(p. 50) to [On]/[Off]/[Auto]. When set to [Auto], DRC is

[Dolby PLII] or [DTS NEO:6]. You can select [Cinema]

automatically turned on for a source with DRC

or [Music] when [DTS NEO:6] is selected. Also you can

information in Dolby TrueHD format. DRC makes the

select [Movie] or [Music] when [Dolby PLII] is selected.

strong sound such as plosive sound lower, and

Off*, Dolby PLII, DTS NEO:6

conversations more audible. It is useful when you watch

movies in the night.

■ System Information

Off

*

, On, Auto

Software version and MAC address (p. 50) are displayed.

■ Speaker Setting

SETTINGS

[Configuration]

You can set the output of 5.1 ch surround depending on

the connected speakers.

1 Press 5 /a to select a speaker you want to configure,

then press ENTER.

2 Adjust the figures below. Note that some of items are

not displayed depend on the selected speaker.

Size When the woofer section of a speaker is 16 cm

(6-1/2 in) or larger, select [Large]. When

smaller than 16 cm (6-1/2 in), select [Small].

Large, Small*

Trim Adjusts the selected speaker’s level (volume

level).

-6 to +6 dB (in 0.5 dB step)

The default setting is 0 dB.

Delay Separately adjusts the timing at which each

speaker produces audio so that sounds from the

speakers reach the listening position at the same

time.

0.5 to 10 m (in 0.5 m step)

The default setting is 3 m.

Disable When selected speaker is not in use, select

[Yes].

English

Yes, No*

39 En